Abstract:Abstract5-Methyl-2-thiophenecarboxaldehyde (MTC)-derived Schiff base was immobilised over SBA-15 (TS-SBA-15) via a two-step modification procedure. Initially, (3-aminopropyl)triethoxysilane (APTES) was heterogenised over SBA-15 (NH2-SBA-15), and the Schiff base formation was followed by a reaction with MTC in hot methanol. X-ray diffraction and transmission electron microscopy showed that the SBA-15, NH2-SBA-15 and TS-SBA-15 materials had mesoscopically ordered, hexagonal symmetry and well-defined morphologies. 29Si magic-angle spinning nuclear magnetic resonance (MAS NMR) spectroscopy revealed a change in the silicon environment during modification. The N2 sorption experiments showed that the material has a large surface area (623 m2 g−1), acceptable pore diameter (6.5 nm) and reasonable pore volume (1.23 cm3 g−1) to accommodate the guest molecules inside the pore channels. Organic functionalisation was determined successfully by Fourier transform infrared and 13C cross-polarisation magic-angle spinning NMR spectroscopy. The optimal condition for the removal of Cr(III), Pb(II) and Zn(II) from water was explored by varying the parameters, such as pH, stirring time, initial concentration and amount of adsorbent. The results suggested that TS-SBA-15 can achieve the adsorption maximum within 6 h at pH 6.5. The adsorbent exhibited moderate-to-good adsorption ability towards the three metal ions under these experimental conditions. The selective adsorption performance of TS-SBA-15 from binary mixture was examined by keeping equal concentrations of metal ions in the mixture. TS-SBA-15 was more selective towards Cr(III) ions from both the binary and ternary mixtures at pH 6.5. The effect of the metal ion concentration over mole adsorption selectivity in the ternary mixture was examined by doubling the concentration of at least one metal ion in the mixture. The result was compared with the ternary mixture containing equal concentrations of metal ions. The reusability test showed that TS-SBA-15 can be recycled for at least six consecutive cycles without losing its adsorption ability.Graphical Abstract

Removal of Cu(Ii) from Aqueous Solution by Adsorption Onto Functionalized Sba-16 Mesoporous Silica

Synthesis of cubic mesoporous silica SBA16 functionalized with carboxylic acid in a one-pot process for efficient removal of wastewater containing Cu 2+ : Adsorption Isotherms, Kinetics, and Thermodynamics

REMOVAL OF AQUEOUS Cu(II) WITH NATURAL KAOLIN: KINETICS AND EQUILIBRIUM STUDIES

Synthesis of functionalized mesoporous silica and its application for Cu(II) removal

Adsorption of Cu(II)–EDTA Chelates on Tri-Ammonium-functionalized Mesoporous Silica from Aqueous Solution

Synthesis of pyridyl Schiff base functionalized SBA-15 mesoporous silica for the removal of Cu(II) and Pb(II) from aqueous solution

Selective removal of Cu(II) ions by magnetic mesoporous silica with surface ion-imprinted quaternized Schiff base coating

High Efficient Removal of Cu(II) by a Chelating Resin from Strong Acidic Solutions: Complex Formation and DFT Certification

Synthesis of thiol-functionalized MCM-41 mesoporous silicas and its application in Cu(II), Pb(II), Ag(I), and Cr(III) removal

Aqueous Cu(ii) ion adsorption by amino-functionalized mesoporous silica KIT-6

Adsorption of platinum(IV) and palladium(II) from aqueous solution by thiourea-modified chitosan microspheres.

Efficient removal of Cu(II) from an aqueous solution using a novel chitosan assisted EDTA-intercalated hydrotalcite-like compound composite: Preparation, characterization, and adsorption mechanism

Effective removal of Cu(II) from water by three-dimensional composite microspheres based on chitosan/sodium alginate/silicon dioxide: Adsorption performance and mechanism

Removal of Cu(II) Ions from Contaminated Water Using Chemically Modified MCM-41

Preparation of Amino-Fe(iii) Functionalized Mesoporous Silica for Synergistic Adsorption of Tetracycline and Copper.

Preparation of SBA-15 mesoporous silica grafted with bis-salicylaldehyde Schiff base for uptake of Pb(II) and Cu(II) from water

Synthesis and Characterization of Thiol-Functionalized Magnetic (Core) Mesoporous Silica-Titanium (Shell-Shell) Nanocomposites for Efficient Copper Ions Removal from Aqueous Solutions

Carboxymethyl Inulin Modified Chitosan Composites for Cu (II) Removal in Aqueous Solution: Synthesis, Influencing Factors and Adsorption Mechanism

Concentration-dependant selective removal of Cr(III), Pb(II) and Zn(II) from aqueous mixtures using 5-methyl-2-thiophenecarboxaldehyde Schiff base-immobilised SBA-15

Removal of Cu(II) from aqueous solution using synthetic poly(catechol-diethylenetriamine-p-phenylenediamine) particles

Amidoxime-functionalized polyacrylamide-modified chitosan containing imidazoline groups for effective removal of Cu2+ and Ni2+