Abstract:Here, an anionic surfactant [AOT]- (bis-(2-ethylhexyl) sulfosuccinate)-stabilized H2O/[Omim][PF6] (1-octyl-3-methylimidazolium hexafluorophosphate) microemulsion has been tested for the first time as a medium for the electropolymerization of 3,4-ethylenedioxythiophene (EDOT). To formulate AOT-stabilized [Omim][PF6]-based microemulsions of different water contents, the phase triangle was determined at 35 °C. Measurements of the conductivities of the microemulsions, their solubilization capacities toward EDOT and their catalytic effects on EDOT electrooxidation show that the present [AOT]--stabilized ionic liquid microemulsion is a good medium for EDOT electropolymerization. Studies on the process of the electropolymerization of EDOT in this [Omim][PF6]-based microemulsion indicate that the water content (i.e., microstructure) of the microemulsion medium is an important factor affecting the onset potential and the deposition rate of the PEDOT. The morphology and the doping level of the as-prepared PEDOT are also found to be correlated with the water content of the ionic liquid microemulsion. The microemulsion with higher water content results in a PEDOT with better electroactivity and higher doping levels. FTIR spectra and XPS analysis show that the PEDOT electrosynthesized in the microemulsion is co-doped by both [AOT]- and [PF6]-. Compared with the neat [Omim][PF6], the use of the ionic liquid microemulsions can reduce not only the consumption of the expensive ionic liquid, but also the onset potential for the electrooxidation of EDOT. Moreover, by tuning the water content of the medium, the electropolymerization of PEDOT and its electrochemical properties could be regulated accordingly. Under the identical deposited charge, the PEDOT originated from the high water content microemulsion (50% H2O μE) has a higher specific capacitance (124 F g-1) than that from neat [Omim][PF6] (117 F g-1). It follows that the present ionic liquid microemulsion is a good medium for EDOT electropolymerization. The present study opens up a new route for the green and low-cost electrochemical preparation of high-performance PEDOT.

Preparation of PEDOT Film by Liquid Phase Depositional Polymerization

Effect of EDOT Solvent on Molecular Structures and Properties of PEDOT Synthesized by Liquid Phase Depositional Polymerization

Ac Electrodeposition Of Pedot Films In Protic Ionic Liquids For Long-Term Stable Organic Electrochemical Transistors

Preparation of Conducting Poly(3,4-ethylenedioxythiophene) and Investigation on Its Properties

Electropolymerization of EDOT in an anionic surfactant-stabilized hydrophobic ionic liquid-based microemulsion.

Synthesis of conducting PEDOT coating on PI film by depositional polymerization in EDOT solution and its application--Feasibility of PCB fabrication by full additive method

Preparation of Water-Dispersive Poly(3,4-Ethylenedioxythiophene) (PEDOT) Conductive Nanoparticles in Lignosulfonic Acid Solution

Enzymatic‐catalyzed polymerization of water‐soluble electrically conductive polymer PEDOT:PSS

Progress on fabrication of poly(3,4-ethylenedioxythiophene) film

Fabrication of Free-Standing Conductive Polymer Films Through Dynamic Three-Phase Interline Electropolymerization

Synthesis and Structure of PEDOT Prepared Through a Modified LB Film Method

Preparation and Characteristics of PEDOT-PSS Conducting Polymeric LB Films

Electrochemical And Optical Properties Of The Poly(3,4-Ethylenedioxythiophene) Film Electropolymerized In An Aqueous Sodium Dodecyl Sulfate And Lithium Tetrafluoroborate Medium

Preparation and characterization of conducting poly(3,4-ethylenedioxythiophene)-poly(styrenesulfonate) Langmuir–Blodgett film

Flexible, Highly Transparent, and Conductive Poly(3,4-ethylenedioxythiophene)-Polypropylene Composite Films of Nanofibrillar Morphology

The morphology and conductivity of PEDOT films under chemical synthesis

STRUCTURE AND ELECTRIC PROPERTIES OF POLY(3,4-ETHYLENEDIOXYTHIOPHENE) FILMS PREPARED THROUGH MODIFICATION OF LB FILM TEMPLATES

Ionic Liquid Induced Supramolecular Self-Assembly of Poly(3,4-Ethylenedioxythiophene)/poly(4-styrenesulfonate) Thin Films with Enhanced Conductivity and Tunable Nanoporosity

Preparation and Properties of Multilayer Poly(3,4-Ethylenedioxythiophene) Langmuir–Blodgett Film

Electrochemical polymerization of 3,4-ethylenedioxythiophene in aqueous micellar solution containing biocompatible amino acid-based surfactant

Structure and Performance of Poly (3,4-ethlenedioxythiophene)/Lignosulfonic Acid (PEDOT/LS) Conductive Compounds