Comprehensive Assessment of Laser Tube Bending Process by Response Surface Methodology
Mehdi Safari,Ricardo Alves de Sousa,Jalal Joudaki
DOI: https://doi.org/10.1002/srin.202200230
IF: 2.1258
2022-07-19
steel research international
Abstract:Laser bending of mild steel tubes is investigated. Six laser tube bending process parameters are selected and carried out by using a continuous wave CO2 laser. The effect of main parameters and their interactions are discussed. Results show that the main and lateral bending angle increase with the laser power, irradiation length, and the number of irradiation passes. The laser beam can be used as a powerful tool for bending tubes and sheets by local heating and buckling mechanism. Herein, the bending of mild steel tubes is investigated by irradiation of the laser beam. To consider the effect of the interaction of process parameters despite previous research, six laser tube bending process parameters in different levels including laser power, scanning speed, laser beam diameter, irradiation length, number of irradiation passes, and irradiation scheme are selected and a set of 92 experimental tests is planned according to the response surface methodology (RSM). The tests have been carried out by using a continuous wave (CW) CO2 laser. The influencing parameters affecting the main bending angle and the lateral bending angle are determined. The effect of main process parameters and their interaction on the main and lateral bending angles are discussed. The axial irradiation scheme (AIS) creates a higher main bending angle compared to the circumferential scanning strategy. The results show that the main bending angle and lateral bending angle increase by increasing the laser power, irradiation length, and the number of irradiation passes and reducing the scanning speed and laser beam diameter. The main and lateral bending angles are determined by a regression equation with about 96% goodness of fitting. The results show that 1100 W laser power, 14.6 mm s−1 scanning speed, 4 mm laser beam diameter, 28.27 mm irradiation length, 1 pass of irradiation, and AIS lead to a simultaneous maximum bending angle of 1.80° and minimum lateral bending angle of 0.152°.
metallurgy & metallurgical engineering