Abstract:Using granulated blast furnace slag (GGBS) as the volcanic ash material and fly ash (FA) as the supplementary material, the study was conducted to investigate the mix proportions of an alkali-activated solid waste cementitious material under the stimulating effect of alkali activator carbide slag (CS). This type of cementitious material could serve as a substitute for a portion of cement usage, contributing to resource conservation and mitigating environmental pollution caused by solid waste. This facilitates green and sustainable development. Firstly, an analysis of three raw materials was conducted, and the mix proportions were designed with reference to the CaO-Al 2 O 3 -SiO 2 system of Portland cement. Then 28 groups of specimens were prepared based on the designed mix proportions. The flowability and setting time of each group of specimens were tested. It was observed that an increase in the amount of CS and a decrease in the amount of GGBS resulted in decreased flowability and earlier setting times of the specimens. Additionally, FA exhibited a retarding effect on setting time. Compressive strength tests were conducted on these specimens, revealing that the optimal CS content ranged between 20 % and 40 %. Overall, FA had minimal impact on compressive strength, but it contributed to increased compressive strength in the specimens at later ages. Subsequently, microscopic characterization of the hydration products was performed using X-ray Diffraction (XRD), Fourier Transform Infrared (FTIR), Differential Thermal Analysis (DTA), Scanning Electron Microscope (SEM), and Energy Dispersive Spectrometer (EDS). The hydration products were identified as predominantly composed of calcium silicate hydrate. The quality and defects in the microstructure of gel products from various specimen formulations were compared to elucidate differences in macroscopic performance. Finally, the hydration process mechanism diagram of alkali-activated materials was presented to illustrate the stimulation and formation of gel products, primarily composed of C-S-H. This diagram revealed the principles behind the action of alkali-activated cementitious materials. The proposed design and testing methodology for the GGBS-FA-CS system in this study had certain reference significance for research in the direction of alkali-activated solid waste cementitious materials.

Hydration Characteristics and Formation Progress of Alinite Cement Prepared from Mswi Fly Ash

MSWI fly ash as alkaline cementitious material admixture

Preparation of Sulphoaluminate-Alite Composite Mineralogical Phase Cement Clinker from High Alumina Fly Ash

Synthesis of high belite sulfoaluminate cement with high volume of mixed solid wastes

SYNTHESIS AND CHARACTERIZATION OF HIGH BELITE SULFOALUMINATE CEMENT THROUGH RICH ALUMINA FLY ASH AND DESULFURIZATION GYPSUM

Preparation and Hydration Properties of Sodium Silicate-Activated Municipal Solid Waste Incineration Bottom Ash Composite Ground-Granulated Blast Furnace Slag Cementitious Materials

Effect of silica fume on the mechanical property and hydration characteristic of alkali-activated municipal solid waste incinerator (MSWI) fly ash

Intermediate-calcium Based Cementitious Materials Prepared by MSWI Fly Ash and Other Solid Wastes: Hydration Characteristics and Heavy Metals Solidification Behavior

Solidification/stabilization and optimization of municipal solid waste incineration fly ash with aluminosilicate solid wastes

Hydrothermal synthesis and characterization of alkali-activated slag-fly ash-metakaolin cementitious materials

Hydration Mechanisms of Alkali-Activated Cementitious Materials with Ternary Solid Waste Composition

Hydration characteristics and hydration products of calcium sulfoaluminate cement and fly ash blended pastes

Manufacture of Alkali-Activated and Geopolymer Hybrid Binder (AGHB) by Municipal Waste Incineration Fly Ash Incorporating Aluminosilicate Supplementary Cementitious Materials (ASCM).

The mechanism of hydrating and solidifying green mine fill materials using circulating fluidized bed fly ash-slag-based agent

Study on the preparation, performance, and mechanism for solid waste cementitious materials

A Novel Method for MSWI Fly Ash Resource Based on Calcium Component Regulation and CO2 Mineralization

Microstructure and properties of the binder of fly ash-fluorogypsum-Portland cement

Influence of solid waste gypsum and additives on the properties of sulfoaluminate cement-fly ash-gangue ternary binder

Recycling Municipal Solid Waste Incineration Fly Ash in Super-Lightweight Aggregates by Sintering with Clay and Using SiC As Bloating Agent.

A novel method for MSWI fly ash resource based on calcium component regulation and CO 2 mineralization

Study on Mechanism of MSWI Fly Ash Solidified by Multiple Solid Waste-Based Cementitious Material Using the Rietveld Method