Electrochemical Quartz Crystal Microbalance Studies on the Codeposition of Dextran Sodium Sulfate with the Charge-Transfer Complexes Generated During Electrooxidation of Benzidine Derivatives

Xueqin Jiang,Zhijun Cao,Tao Liu,Qingji Xie,Shouzhuo Yao
DOI: https://doi.org/10.1002/elan.200704132
IF: 3.077
2008-01-01
Electroanalysis
Abstract:The electrochemical quartz crystal microbalance (EQCM) technique was used to investigate the electrochemistry of three benzidine derivatives, o-tolidine (o-TD), 3,3',5,5'-tetramethyl-benzidine (TMB) and o-dianisidine (o-DA), in Britton-Robinson (B-R) buffer solutions with and without coexisting dextran sodium sulfate (DSS), respectively. During the anodic potential sweep from 0.1 to 0.7 V vs. SCE in pH 5.0 B-R buffer solution containing o-TD, the EQCM frequency was decreased during the first-step oxidation of o-TD and then increased to some extent during its second-step oxidation, implying that a poorly soluble charge-transfer complex (CTC) was produced here as an oxidation intermediate, and its precipitation and then dissolution at the EQCM Au electrode decreased and then increased the frequency. The depth of the V-shaped time-dependent frequency response (- Delta f(0v)) to the redox switching of the CTC/o-TD couple (0.1 - 0.37 V vs. SCE) was notably enhanced in the presence of DSS, being due to the formation of a mass-enhanced CTC-DSS adduct via electrostatic affinity. Similar phenomena were evident in the TMB system, but the CTC behavior was not observed during o-DA oxidation in the absence of DSS, namely, the EQCM frequency kept decreasing all the time, due probably to the too high lability of the CTC from o-DA oxidation, and the coexistence of DSS could well stabilize this CTC and turn on its CTC behavior. The o-TD system showed the highest sensitivity to DSS and was thus examined in detail. The mechanism for the CTC-DSS interaction is discussed from EQCM, FT-IR and UV-vis data. The CTC-based EQCM determination of DSS, which is featured by a dynamically renewed surface of the detection electrode, was thus proposed, with a linear range from 0.002 to 1.6 mu mol L-1 and a detection limit down to 0.7 nmol L-1 (o-TD system).
What problem does this paper attempt to address?