Abstract:SiC layer was prepared in an industrial scale spout fluidized bed by chemical vapor deposition. The density of SiC coating was about 3.18 g/cm(3). High temperature oxidation experiments were carried out at different temperatures from 800 to 1600 degrees C. The microstructure and composition were characterized using different methods, including mass change weighing, XRD, EDS and SEM. It was found that the weight gain of SiC coating layer was not obvious below 1200 degrees C, and subsequent mass gain gradually increased with increasing temperature, reaching 10% at 1600 degrees C. High-magnification SEM results show that the oxidation began from the surface and gradually formed punctate distribution of the oxide. Small crystal structure (similar to micron) of the SiC surface was very clear at 1000 degrees C, and this crystal structure disappeared gradually at high temperatures, forming oxides of Si in the SiC surface. There was a stacking fault stress due to the different thermal expansion coefficients and elastic modulus of SiC and Si oxides, leading to the gradual formation of cracks around the punctates. With increasing temperature, the crack further increased the oxidation rate of SiC, and finally the formed Si oxides layer fell off from the particles. It can be seen clearly that the layer was peeling when the temperature was increased to 1400 degrees C. Increasing the temperature to 1600 degrees C, the SiC coating was oxidized completely into a honeycomb structure, with obvious sintering of SiC. XRD analysis shows that there was a growing SiO2 peaks from 1400 degrees C, indicating that surface oxidation was significant. EDS results shows that the oxygen content in the coating surface gradually increased with increasing temperature. Semi-quantitative analysis shows that the surface was close to SiO2 at 1600 degrees C.

High Temperature Oxidation Behavior of Ternary Layered Ti3SiC2 Ceramic

High Temperature Oxidation Resistance Of Ti3sic2 In Air And Low Oxygen Atmosphere

High Temperature Oxidation Behavior of Ti_3AlC_2 Ceramics Prepared by SHS/PHIP

Oxidation Resistance Performance of Si3N4/TiN Multiphase Ceramic

Comparative Study on the Oxidation Behavior of Si2BC3N/Ta4HfC5 Ceramics at 1000 °C and 1500 °C: Microstructural Evolution and Kinetics Consideration

Cyclic Oxidation of Ternary Layered Ti2AlC at 600–1000°C in Air

Investigation of the oxidation mechanism of Si-Al2O3-fused mullite containing Ti2O3 composite

Cyclic Oxidation Behavior of TiC/Ti3AlC2 Composites at 550–950 °C in Air

Oxidation Behavior of TiC-containing Ti3AlC2based Material at 500–900 °C in Air

Microstructure evolution during oxidation of quinary Ti 3 (AlSiSn)C 2 at high temperatures and induced probable performance

High Temperature Oxidation Behavior of SiC Coating Materials

Cyclic Oxidation of Ti3AlC2 at 1000–1300 °C in Air

High temperature oxidation behavior and mechanism of SiC-TaB2 composites

Oxide Scale Microstructure and Scale Growth Kinetics of the Hot-Pressed SiBCN-Ti Ceramics Oxidized at 1500 °C

The Oxidation Resistance Mechanism of SiC-B4C-xAl2O3 Ceramics at 1400 ℃ in Air Atmosphere

Experimental and first-principles simulation study on oxidation behavior at 1700 °C of Lu2O3–SiC-HfB2 ternary coating for SiC coated carbon/carbon composites

High-temperature oxidation behavior and mechanism of Si3N4/Si3N4w/TiN nanocomposites ceramic cutting tool materials

Oxidation behavior and kinetics of (Zr, Ti)(C, N)–SiC ceramics with enhanced oxidation resistance at 850 °C–950 °C

Microstructure and High-Temperature Oxidation Resistance of Ti-6Al-4V Alloy with In-Situ SiC-SiO2 Nano-Composite Coating by LPDS Technique

High temperature oxidation behavior of reaction-bonded silicon carbide

Preparation of Ternary Layered Ti3SiC2 Ceramic by SHS/PHIP