Abstract:In this paper, biodiesel wastewater was treated by catalytic combustion in the case of catalyst coupling. The effects of reaction temperature, residence time and air flow on the treatment of biodiesel wastewater were investigated using the Fe2O3 catalyst, the Pt/Al2O3@cordierite catalyst and the Fe2O3 catalyst coupled with the Pt-based catalyst. The effects of high-temperature hydrothermal treatment on the two catalysts were evaluated. The catalytic stability was studied in continuous catalytic combustion. Detailed characterization of the two catalysts was carried out. The X-ray fluorescence (XRF), X-ray diffraction (XRD) and X-ray photoelectron spectroscopy (XPS) characterization demonstrated that the Fe2O3 catalyst contained a significant amount of surface active oxygen and Fe2O3 existed in an amorphous form within the catalyst. The Fe2O3 catalyst could remove 90.6% of sulfur from wastewater, showing excellent desulfurization performance, but it was not resistant to high temperature. After 500 degrees C hydrothermal treatment, the chemical oxygen demand (COD) removal rate decreased significantly from 97.98% to 69.04% at the reaction temperature of 280 degrees C. The COD removal rate of the Pt/Al2O3@cordierite catalyst was almost 100% at the reaction temperature of 320 degrees C, with the activity being basically unchanged after high-temperature hydrothermal treatment, but sulfur poisoning occurred. The Fe2O3 catalyst coupled with the Pt/Al2O3@cordierite catalyst showed excellent catalytic activity and stability, and the optimal reaction temperature and residence time were 320 degrees C and 0.3 s, respectively. In the continuous treatment of biodiesel wastewater with the COD of 99 465 mg L-1 for 200 h, the COD and sulfur content of the treated wastewater were less than 400 mg L-1 and 1 mg L-1, with the COD removal rate and sulfur removal rate exceeding 99.62% and 81.38%, respectively. In addition, no organic gas or SO2 was detected in the exhaust gas generated during the reaction, and the removed organic matter was converted into CO2 and H2O.

Effect of catalyst FH-UDS on catalytic cracking diesel fuel hydrodearomatization

Causes for Deactiation of the Catalysts for Hydrogenation of Furfural to Furfurol

Co-hydrotreating of Algae and Used Engine Oil for the Direct Production of Gasoline and Diesel Fuels or Blending Components

Effects of Ga- and P-modified USY-based NiMoS catalysts on ultra-deep hydrodesulfurization for FCC diesels

The Effect of Hydrophobically Modified Iron Catalysts with Hexadecyltrimethoxysilane on Fischer‐Tropsch Synthesis

Oxidative Desulfurization of FCC Diesel Oil Using Amphiphilic Catalyst Combined with Solvent Extraction

Comparative Study on Hydrotreating of Venezuela De-Asphalted Oil: Conversion Behavior of Heteroatom Compounds and HDM Catalyst Deactivation

Exploratory Study on Ultrasonic Oxidation Desulfurization of Catalytic Cracking Diesel Oil

Catalytic Combustion of Biodiesel Wastewater over the Fe2O3 Catalyst Coupled with a Pt-based Catalyst

Effect of Methanol on Catalytic Performance of Hy Zeolite for Desulfurization of Fcc Gasoline by Alkylation

Studies on Pretreatment of Catalytic Cracking Slurry Oil with Added Furfural

Study on the Effect of Catalyst Properties on Residue Hydroconversion

An Insight into Effect of Methanol on Catalytic Behavior of Amberlyst 35 Resins for Alkylation Desulfurization of Fluid Catalytic Cracking Gasoline

Effective Reduction of Hydrogen Consumption in Ultra-Deep Hydrodesulfurization of Diesel: Deep Insights into the Effect of Thermodynamic Limitations During Hydrotreating

Hydrocracking of Bio-Alkanes over Pt/Al-MCM-41 Mesoporous Molecular Sieves for Bio-Jet Fuel Production

Effect of characteristic component on diesel steam reforming to hydrogen over highly dispersed Ni-Rh- and Ni-based catalysts: Experiment and DFT calculation study

Effect of Polycyclic Aromatic Hydrocarbons on the Stability of Hydrogenation Catalyst for Producing Ultra-Low Sulfur Diesel

Hydrodesulfurization of diesel in a slurry reactor

Tuning physicochemical properties of hierarchically ZSM-5/FDU-12 composite material and its catalytic hydrodesulfurization performance for diesel

A coupling model of fluid catalytic cracking and diesel hydrotreating processes to study the effects of reaction temperature on the composition of diesel

Study of Fluid Catalytic Cracking Process in Experimental Downer Reactor