Abstract:In this study, a neural network approach is presented for the prediction and control of surface roughness in a computer numerically controlled (CNC) lathe. Experiments have been performed on the CNC lathe to obtain the data used for the training and testing of a neural network. The parameters used in the experiment were reduced to three cutting parameters which consisted of depth of cutting, cutting speed, and feed rate. Each of the other parameters such as tool nose radius, tool overhang, approach angle, workpiece length, workpiece diameter and workpiece material was taken as constant. A feed forward multi-layered neural network was developed and the network model was trained using the scaled conjugate gradient algorithm (SCGA), which is a type of back-propagation. The adaptive learning rate was used. Therefore, the learning rate was not selected before training and it was adjusted during training to minimize training time. The number of iterations was 8000 and no smoothing factor was used. Ra, Rz and Rmax were modeled and were evaluated individually. One hidden layer was used for all models while the numbers of neurons in the hidden layer of the Ra model were five and the numbers of neurons in the hidden layers of the Rz and Rmax models were ten. The results of the neural network approach were compared with actual values. In addition, inasmuch as the control of surface roughness is proposed, a control algorithm was developed in the present investigation. The desired surface roughness was entered into the control system as a reference value and the controller determined the cutting parameters for these surface roughness values. A new surface roughness value was determined by sending the cutting parameters to the observer (ANN block). The obtained surface roughness was fed back to the comparison unit and was compared with the reference value and the difference surface roughness was then sent to the controller. The iteration was continued until the difference was reduced to a certain value of surface roughness which could be permitted for machining accuracy. When the surface roughness reached the permitted value, these cutting parameters were sent to the CNC turning system as input values. In conclusion, both the surface roughness values corresponding to the cutting parameters and suitable cutting parameters for a certain surface roughness can be determined prior to a machining operation using the ANN and control algorithm.

Surface Profile Prediction and Analysis Applied to Turning Process

Pre-evaluation on Surface Profile in Turning Process Based on Cutting Parameters

An Intelligent Prediction of Surface Roughness on Precision Grinding

Adaptive network-based fuzzy inference system with leave-one-out cross-validation approach for prediction of surface roughness

Surface Roughness Prediction in Turning of Free Machining Steel 1215 by Artificial Neural Network

Study on prediction of surface quality in machining process

Grinding Surface Roughness Prediction Model Based on RBF Neural Network

Prediction and control of surface roughness in CNC lathe using artificial neural network

Research on Surface Roughness Prediction of Turning Parts Based on Bp Artificial Neural Network

Intelligent Prediction for Surface Roughness of Cnc Surface Grinding Machine Tool Based on Bayesian Network

Prediction of surface roughness in CNC face milling using neural networks and Taguchi's design of experiments

Analysis and prediction of tool wear, surface roughness and cutting forces in hard turning with CBN tool

A comparison of machine learning methods for cutting parameters prediction in high speed turning process

Surface Roughness Prediction Based on Cutting Parameters and Nose Radius in Precision Turning

A novel approach for prediction of surface roughness in turning of EN353 steel by RVR-PSO using selected features of VMD along with cutting parameters

Study on Analytical Model of Surface Roughness Prediction in NC Machining

Surface roughness predictive modeling: neural networks versus regression

Prediction of surface roughness in duplex stainless steel face milling using artificial neural network

An Advanced Approach for Predicting Workpiece Surface Roughness Using Finite Element Method and Image Processing Techniques

Estimation of surface quality for turning operations using machine learning approach

Using Neural Networks for Tool Wear Prediction in Computer Numerical Control End Milling