Abstract:Pure TiO₂ nanoparticles and ones doped with Fe and/or Ni were successfully prepared by a co-precipitation method from ilmenite. The samples were structurally characterized by XRD, XPS, FT-IR, UV-vis, SEM, EDX, AAS and BET measurement. The XRD results showed that all samples were anatase TiO₂, and no characteristic peaks of dopants were observed. The crystallite sizes of all doped TiO₂ nanoparticles were less than 20 nm and doping TiO₂ with metal ions can suppress the crystal growth of the particles. The XRD and XPS results indicated that TiO₂ was uniformly doped and its crystalline phase was not changed by doping. The specific surface area of Fe-Ni/TiO₂ is bigger than that of the un-doped TiO₂. The pore size and pore volume of Fe-Ni/TiO₂ is smaller than that of the un-doped. UV-vis spectra of the samples showed that the absorption edge red shifted with increasing doped metal content. The photocatalytic activity was evaluated in oxidative degradation of methylene blue (MB) with H₂O₂ under visible light irradiation. When doped with a single type of transition metal, the photocatalytic performance of Ni-doped samples was lower than that of Fe-doped ones. For the co-doped catalysts, the catalytic efficiency of 0.5%Fe₄%Ni/TiO₂ was the highest, reaching 93.34% after 250 min. Metal doping enhanced the photocatalytic decomposition of methylene blue compared with that of pure TiO₂ by up to 1.5 times. The synergistic effects of the two metal ions improved the photocatalytic performance. The particles exhibited pronounced activity in degradation of MB as well as efficient recyclability. The photocatalytic degradation mechanism of methylene blue was analyzed.

Preparation of Fe-doped TiO2 nanotube arrays and their photocatalytic activities under visible light

Facile Fabrication of N-doped TiO2 Nanocatalyst with Superior Performance under Visible Light Irradiation

Influence of Fe2o3 Doping on Morphology and Photocatalytic Activity of Tio2 Prepared by Adsorption Phase Synthesis

Preparation of Fe3+ Doped High-Ordered TiO2 Nanotubes Arrays with Visible Photocatalytic Activities

Preparation and visible-light photocatalytic performance of Fe2 O3/TiO2 composite nanotube arrays

Preparation and Photocatalytic Properties of V-doped TiO_2 Nanotube Arrays

Synthesis of α-Fe2O3/TiO2 nanotube arrays for photoelectro-Fenton degradation of phenol

Preparation, Characterization and Electronic Structures of Fe-doped TiO2 Nanostructured Fibers

Fabrication of Fe2O3/TiO2 Nanotube Electrode and Its Photoelectrocatalytic Performance in Dye Wastewater Degradation

Fabrication of Fe 2 O 3 /TiO 2 Nanotube Electrode and Its Photoelectrocatalytic Performance in Dye Wastewater Degradation: Fabrication of Fe 2 O 3 /TiO 2 Nanotube Electrode and Its Photoelectrocatalytic Performance in Dye Wastewater Degradation

Photonic, and Photocatalytic Behavior of Tio2 Mediated by Fe, Co, Ni, N Doping and Co-Doping

Preparation, characterization and visible-light-driven photocatalytic activity of Fe-doped titania nanorods and first-principles study for electronic structures

Synthesis of carbon-modified TiO2 nanotube arrays for enhancing the photocatalytic activity under the visible light

Preparation and Visible Light Photocatalytic Properties of (er, La, N)-codoped TiO2 Nanotube Array Films.

Research on Cu-doped TiO_2 Nanotube Arrays

Preparation Of Fe3+-Doped Tio2 Nanoparticles And Their Photocatalytic Activities

Preparation and Properties of Nanocrystalline Α‐fe2o3‐sensitized TiO2 Nanosheets As a Visible Light Photocatalyst

Synthesis, Characterization and Photocatalytic Activity of Visible-light-driven N-P-codoped TiO_2 Nanotubes

Visible-Light Photocatalytic Activity of Fe And/or Ni Doped Ilmenite Derived-Titanium Dioxide Nanoparticles

Iron-doped TiO2 nanotubes with high photocatalytic activity under visible light synthesized by an ultrasonic-assisted sol-hydrothermal method

Preparation and Enhanced UV Visible Light Photoelectrocatalytic Activity of TiO2 Fe2O3/Cu Ternary Nanocomposites