Platinum nanowire nanoelectrode array for the fabrication of biosensors.

Minghui Yang,Fengli Qu,Yashuang Lu,Yan He,Guoli Shen,Ruqin Yu

DOI: https://doi.org/10.1016/j.biomaterials.2006.08.014

IF: 14

2006-01-01

Biomaterials

Abstract:Platinum nanowire arrays can be grown by electrodeposition in polycarbonate membrane, with the average diameter of the nanowires about 250nm and the height about 2μm. The nanowire array prepared by the proposed method can be considered as nanoelectrode array (NEA) with nanoelectrode density of 5×108cm−2. While the NEA can improve the signal-to-noise ratio and decrease the detection limit, the high surface area of the platinum NEA circumvents the problem of conventional platinum electrodes associated with the limited electroactive site. The platinum NEA can direct response to hydrogen peroxide at low potential of 0V with wide linear range (1×10−7–6×10−2m) and sensitivity 50 times larger than that of the conventional platinum electrode. With the absorption of glucose oxidase onto the ordered NEA surface, the spatially patterned glucose oxidase improves greatly the resulting biosensor. The biosensor can achieve interference free determination of glucose with wide linear range (10−6–3×10−2m). The sensitivity of the glucose biosensor is one-fifth of the sensitivity toward hydrogen peroxide, indicating high efficiency of signal transduction. The biosensor was used to determine glucose in real blood samples, and the glucose contents determined by the present biosensor were in agreement with the results of existing method.