Abstract:Mold flux, which plays an important role in continuous casting, occurs when liquid slag on top of the molten steel infiltrates the gap between the shell and mold. During this process, a liquid slag film forms on the shell side, whereas a solid slag film forms on the mold side. The behavior of the slag film between the shell and mold has a significant effect on the sequence casting and quality of the slab surface. To investigate the in-mold behavior and heat transfer of slag film, researchers have simulated the formation of slag film in the laboratory. Measurements and theoretical calculations have been performed to study the heat transfer of slag film. In this paper, the experimental methods used to simulate the formation of slag film were described and the research related to heat transfer in slag film was summarized, including the interfacial thermal resistance, the thermal conductivity of the mold flux, radiative heat transfer, and optical properties of the slag film. The issues related to the formation and heat transfer of slag film were also identified, that require further investigation. The results of recent studies indicate that the hot thermocouple technique could be applied to observe the formation of slag film, and the copper-finger dig test could be used to obtain samples for investigations related to the microstructure of solid slag film. The interfacial heat resistance is reported to be between 0.0002 and 0.002 m2·K·W-1. The thermal conductivity of mold flux at 800℃ ranges from 1.0-2.0 m2·K·W-1, and increases with increased temperature. Crystals in the solid slag film not only increase the interfacial heat resistance, but also decrease the radiative heat flux by reducing the reflectivity of slag film. Furthermore, due to the resulting change in optical properties, the addition of transition metal oxides and fine particles dispersed in slag film may also influence the radiative heat transfer through slag film.

Forming Process and Heat Transfer of the Solid Mold Flux Film

Heat Flux Through Slag Film and Its Crystallization Behavior

Research Overview of Formation and Heat Transfer of Slag Film in Mold During Continuous Casting

Study on Microstructure of Slag Film for Mold Fluxes

The Observation of Mold Flux Crystallization on Radiative Heat Transfer

Effect of Mold Slag Film Structure on Heat Transfer

Study of Solidification and Heat Transfer Behavior of Mold Flux Through Mold Flux Heat Transfer Simulator Technique: Part I. Development of the Technique

The effect of in-situ dynamic mold flux melting and crystallization on heat transfer in continuous casting

Simulation of the Effect of Flux Layer Thickness on the Melting Behavior of Mold Fluxes Based on the Copper Bath Method

Structure of Solidified Films of CaO-SiO2-Na2O Based Low-Fluorine Mold Flux

Effect of mold flux melting and crystal fraction dissolution on radiative heat transfer in continuous casting

Investigation on heat transfer performance of fluoride-free and titanium-bearing mold fluxes

Evolution of Temperature and Solid Slag Film During Solidification of Mold Fluxes

Structure of Solidified Films of Mold Flux for Peritectic Steel

Experiment on solidification and composition segregation of solidified mold flux film for peritectic steel continuous casting

Study of Solidification and Heat Transfer Behavior of Mold Flux Through Mold Flux Heat Transfer Simulator Technique: Part II. Effect of Mold Oscillation on Heat Transfer Behaviors

Study of basicity impact on mold flux crystallization and radiative heat transfer in continuous casting

Investigation of Liquid/Solid Slag and Air Gap Behavior Inside the Mold During Continuous Slab Casting

Simulation and Characterization on Heat Transfer Through Mould Slag Film

Radiative Heat Transfer Behavior Of Mold Fluxes For Casting Low And Medium Carbon Steels

Influence of Mineralogical Structure of Mold Flux Film on Heat Transfer in Mold during Continuous Casting of Peritectic Steel