Abstract:Manifold microchannel heat sink is promising to dissipate high heat fluxes for electronic devices due to its high surface to volume ratio. Traditional Z-type manifold encounters fluid flow maldistribution and a high temperature difference. In this work, two inlets and countercurrent flows are introduced into the manifold arrangement to alleviate these problems in the Z-type manifold microchannels. Six cases with different manifold arrangements are numerically investigated using single-phase HFE-7100 at mass flow rates ranging from 56.8 to 117.78 mg/s. The results show that the maximum temperature, average temperature, and temperature difference of the revised arrangements are all lower than these of the traditional Z-type manifold arrangement. The minimum temperature difference for an ideal multi inlet manifold arrangement can be less than 0.2 K, while the value is about 5.3 K for the traditional Z-type manifold arrangement. The revised arrangement can also improve the uniformity of mass flux distributions. The ratio of the maximum to the minimum mass flux within microchannels is 12.83 for the traditional Z-type manifold, while this value is about 5.82 for cases with two inlets and countercurrent zones. A longer flow path and a higher local pressure drop in the revised arrangements results in higher pressure drops than the traditional Z-type manifold microchannels. Compared with the traditional Z-type arrangement, heat transfer coefficients and performance evaluation criterion are higher for the improved cases. The presence of a countercurrent zone can improve the comprehensive performance of the manifold microchannel. New criterion based on the thermal resistance calculated at the maximum temperature is proposed to evaluate the cooling performance of electronics.

Experimental study of constructal distributor for flow equidistribution in a mini crossflow heat exchanger (MCHE)

Improvements on Maldistribution of a High Temperature Multi-Channel Compact Heat Exchanger by Different Inlet Baffles

A numerical and experimental study of chevron, corrugated-plate heat exchangers

Experimental study on the performance of a novel structure for two-phase flow distribution in parallel vertical channels

Effects of Distribution Channel Dimensions on Flow Distribution and Pressure Drop in a Plate‐Fin Heat Exchanger

Effect of Inlet Flow Maldistribution on the Passage Arrangement Design of Multi-Stream Plate-Fin Heat Exchanger

Experimental Study of A Novel Manifold Structure of Micro-Channel Heat Exchanger

Design Method and Application Effects of Embedded-Clapboard Distributor on Refrigerant Distribution among Multi-Tubes of Micro-Channel Heat Exchangers

Experimental investigation on fluid flow maldistribution in plate-fin heat exchangers

Optimal designs for flow uniformity at inlet of microchannel flat tube heat exchanger

Numerical simulation and experiment of laminar heat transfer characteristics in micro-channel collector

Experimental Investigation of the Flow Distribution of a 2-Dimensional Constructal Distributor

A Mathematical Model for Flow Maldistribution Study in a Parallel Plate-Fin Heat Exchanger

Experimental and Numerical Study of Flow Distributor of Intermediate Heat Exchanger in High Temperature Gas-Cooled Reactor

Thermal Performance of Crossflow Microchannel Heat Exchangers

Analysis Exploring The Uniformity Of Flow Distribution In Multi-Channels For The Application Of Printed Circuit Heat Exchangers

Flow Distribution Performance of Different Distributor's C onfiguration in Plate-Fin Heat Exchanger

NUMERICAL STUDY ON FLOW AND HEAT TRANSFER PERFORMANCE OF A NOVEL MULTILAYER MINI-CHANNEL HEAT EXCHANGER WITH LOW AXIAL HEAT CONDUCTION

Analytical and Experimental Investigation of Flow Distribution in Manifolds for Heat Exchangers

Thermal and hydrodynamic characteristics of single-phase flow in manifold microchannels with countercurrent regions

Numerical Investigation of Constructal Distributors with Different Configurations