Effects of Sample Width Towards the Spread of Upward Flame over EPDM Rubber Waterproof Sheet
Chun-ming XU,Rui-fang ZHANG,Qi-yuan XIE,Li-ming LI,Dong-mei HUANG,He-ping ZHANG
DOI: https://doi.org/10.3969/j.issn.1009-6094.2010.06.035
2010-01-01
Abstract:Previous studies have demonstrated combustion behaviors are affected by sample width. To study the effects of sample width on upward flame spread, full-scale experiments have been carried out in an ISO 9705 standard room. Samples used are 0.2 cm thick EPDM rubber waterproof sheets with fixed height of 120 cm and varied widths of 5 cm, 10 cm, 15 cm, 20 cm, 25 cm, 30 cm, and 40 cm. Parameters associated with fire behaviors, such as heat release rate (HRR), heat flux and flame height depending on the sheet width (w) are measured. Analysis of the data indicates that HRR increases with the width of the sheet. There are two HRR peak values with widths between 5 - 20 cm and the first HRR peak value is not obvious when width increases to 25 cm. For w≥30 cm, there's only one peak value remained. Flame height is an important parameter for combustion behaviors which can affect the flame development and radiation properties. The increasing width leads to an increase of flame height and average speed of upward flame spread for w≤ 25 cm, and to a decrease for w≥ 25 cm, which may be related to the effects of lateral spread. 25 cm can be taken as the critical width. Previous work has demonstrated a relationship between HRR and flame height per unit width, X_f/W = αQ(?) and the present experimental data show good agreement with this formula. Value 1.08 is taken for the samples as the power, n. According to the relationship between total heat flux and flame height, we have established a dependence of heat flux on the height normalized by a scale length representing the flame height.