Abstract:The effects of different modeling and solving approaches on the simulation of a steam ejector have been investigated with the computational fluid dynamics (CFD) technique. The four most frequently used and recommended turbulence models (standard k-ε, RNG k-ε, realizable k-ε and SST k-ω), two near-wall treatments (standard wall function and enhanced wall treatment), two solvers (pressure- and density-based solvers) and two spatial discretization schemes ( the second-order upwind scheme and the quadratic upstream interpolation for convective kinematics (QUICK) of the convection term have been tested and compared for a supersonic steam ejector under the same conditions as experimental data. In total, more than 185 cases of 17 different modeling and solving approaches have been carried out in this work. The simulation results from the pressure-based solver (PBS) are slightly closer to the experimental data than those from the density-based solver (DBS) and are thus utilized in the subsequent simulations. When a high-density mesh with y+ < 1 is used, the SST k-ω model can obtain the best predictions of the maximum entrainment ratio (ER) and an adequate prediction of the critical back pressure (CBP), while the realizable k-ε model with the enhanced wall treatment can obtain the best prediction of the CBP and an adequate prediction of the ER. When the standard wall function is used with the three k-ε models, the realizable k-ε model can obtain the best predictions of the maximum ER, and the three k-ε models can gain the same CBP value. For a steam ejector with recirculation inside the diffuser, the realizable k-ε model or the enhanced wall treatment is recommended for adoption in the modeling approach. When the spatial discretization scheme of the convection term changes from a second-order upwind scheme to a QUICK scheme, the effect can be ignored for the maximum ER calculation, while only the CBP value from the standard k-ε model with the standard wall function is reduced by 2.13%. The calculation deviation of the ER between the two schemes increases with the back pressure at the unchoked flow region, especially when the standard k-ε model is adopted. The realizable k-ε model with the two wall treatments and the SST k-ω model is recommended, while the standard k-ε is more sensitive to the near-wall treatment and the spatial discretization scheme and is not recommended for an ejector simulation.

Shock Circle Model for Ejector Performance Evaluation

Experimental and numerical investigation of the effect of shock wave characteristics on the ejector performance

An Investigation on the Component Efficiencies of a Small Two-Phase Ejector

Numerical Simulation of the Performance of the Sc-89 Jet Impact System

Simplified Ejector Model for Control and Optimization

Novel Ejector Model for Performance Evaluation on Both Dry and Wet Vapors Ejectors

Development of Control Model for Critical Operation Ejector

Effect of Relative Positions between Blade and Volute Tongue on Prediction of Performance in Simulation of Centrifugal Pump

A theoretical model for performance evaluation of a novel configuration of supersonic ejectors

Novel Ejector Model with Experimental Validation

An extended mechanism model of gaseous ejectors

Thermodynamic performance modeling, optimization and numerical simulation of RBCC ejector mode

Assessment of Different CFD Modeling and Solving Approaches for a Supersonic Steam Ejector Simulation

Numerical Investigation on the Effect of Section Width on the Performance of Air Ejector with Rectangular Section

A 1D Model for the Unsteady Gas Dynamics of Ejectors

Numerical Investigation of Geometry Parameters for Design of High Performance Ejectors

Experimental Investigation of an Improved Ejector with Optimal Flow Profile

Numerical Simulations of Shock/obstacle Interactions Using an Improved Ghost-Cell Immersed Boundary Method

Transient numerical study of CO 2 two-phase flow in a needle adjustable ejector

Working Mechanism and Characteristics Analysis of a Novel Configuration of a Supersonic Ejector

Quasi-two-dimensional Ejector Model for Anode Gas Recirculation Fuel Cell Systems