Abstract:Based on the recently constructed n-body potential, both molecular dynamics and Monte Carlo simulations revealed that the Al-Zr amorphous alloy or metallic glass can be obtained within the composition range of 24–66 at. % Zr. The revealed composition range could be considered the intrinsic glass-forming range and it quantitatively indicates the glass-forming ability of the Al-Zr system. The underlying physics of the finding is that, within the composition range, the amorphous alloys are energetically favored to form. In addition, it is proposed that the energy difference between a solid solution and the amorphous phase could serve as the driving force of the crystalline to amorphous transition and the driving force should be sufficiently large for amorphization to take place. The minimum driving forces for fcc Al-based and hcp Zr-based Al-Zr solid solutions to amorphize are calculated to be about −0.05 and −0.03 eV/atom, respectively, whereas the maximum driving force is found to be −0.23 eV/atom at the alloy stoichiometry of Al60Zr40. A thermodynamics parameter γ¯, defined as the ratio of the driving force to the formation energy of the solid solution, is further proposed to indicate the glass-forming ability of an Al-Zr alloy. Thermodynamics calculations show that the glass-forming ability of the Al56Zr44 alloy is the largest, implying that the Al56Zr44 amorphous alloy is more ready to form than other alloys in the Al-Zr system. Besides, Voronoi analysis found that there exists a strong correlation between the coordinate number and structure. Amorphization could result in increase of coordinate numbers and about 1.5% volume-expansion. The volume-expansion induced by amorphization can be attributed to two factors, i.e., the total bond number of the Al-Zr amorphous phase is greater than that of the corresponding solid solution, and the averaged bond length of the Al-Zr amorphous phase is longer than that of the corresponding solid solution. For the Al-Zr alloys, especially for the Al-Zr amorphous phase, there exists a negative chemical micro-inhomogeneity in the alloys, suggesting that metallic bonds prefer to be formed between the atoms of dissimilar species. Finally, it is found that there is a weak correspondence between the bond-angle distributions of Al-Zr amorphous alloys and the solid solutions. It is further suggested that the configuration of Al-Zr amorphous alloys embodies some hybrid imprint of bcc, fcc, and hcp structures. More interestingly, the short-range order is also observed in the bond-angle distributions.

Stability and Thermodynamic Properties of Supersaturated Solid Solution and Amorphous Phase Formed by Ball Milling in the Zr- Al System

Amorphization of Zr–Al Solid Solutions under Mechanical Alloying at Different Temperatures

Calorimetric Evidence for Polymorphous Constraints on Metastable Zr-Al Phase Formation by Mechanical Alloying

The Forming Mechanism and Thermal Stability of W-Zr Super-Saturated Solid Solution Powder Prepared by Mechanical Alloying

Amorphization Of Zr-Al Under Mechanical Alloying At Different Temperatures: A Re-Entrant Melting Phenomenon

Enthalpies of Formation and Crystallization of Amorphous Zr1-xAlx and Zr1-xNix Alloys: Calculations Compared with Measurements

Amorphization in the AlC System by Mechanical Alloying

Crystallization of high stable Zr55Al10Ni5Cu30 bulk amorphous alloy

Thermodynamics and kinetics of the oxidation of amorphous Al-Zr alloys

Formation and structure of Al-Zr metallic glasses studied by Monte Carlo simulations

Phase equilibria thermodynamics and solidified microstructure in the Ag-Cr-Zr system

THERMODYNAMICAL ANALYSIS ON THE METASTABLE TRANSITIONS OF A MULTI-PHASE Al3Ti-BASED INTERMETALLIC COMPOUND DURING HIGH-ENERGY BALL-MILLING

Effect of Ti and Al Ratio on Glass Forming Ability and Crystallization Behavior of Zr-Cu-Al-Ti Alloy Powders

New Insights into Solidification and Phase Equilibria in the Al-Al3Zr System: Theoretical and Experimental Investigations

Formation of 25 Mol% Fe2o3-Al2o3 Solid Solution by High-Energy Ball Milling

Isothermal Stability and Selected Mechanical Properties of Zr48Cu36Al8Ag8 Bulk Metallic Glass

Crystallization of Amorphous Zr60Al15Ni25 Alloy

Ab initio Molecular Dynamics Study of Local Atomic Structure Evolution of U–Zr Alloy Melts upon Solidification

Thermal Stability of Zr55Al10Ni5Cu30 Bulk Amorphous Alloy During Continuous Heating and Isothermal Annealing

Solidification paths and phase equilibria at 873 and 673 K in the Al-Er-Zr system

Solidification Pathways and Constituent Phases of Mg–Zn–Y–Zr Alloys