Abstract:Rock formations experience strength and stiffness degradation or enhancement, which is often reflected by an increase or decrease in the elastic constant. Such elastic constant variation in rock mass often causes the redistributions of the stress and strain; therefore, the geostructure stability is affected. However, to the best of the authors’ knowledge, no studies have been conducted to investigate this problem analytically. Therefore, based on Hooke’s law, this paper analyzed the stress, strain, and energy density distributions in a rock formation with such a variation in the elastic constant. Then, a general analytical solution was presented for two scenarios. One scenario was the elastic constant variation over the whole domain of rock mass, and the other was the elastic constant variation over the partial domain of interest. According to the law of thermodynamics, the elastic constant and stress components could be expressed as a function of the elastic strain energy density (ψ). Then, the stress and strain components distributions after the elastic constant variation could be directly correlated to those that developed before the elastic constant variation. The analysis showed that the stress components before and after the elastic constant variations were unchanged for the case with a variation in the elastic constant over the whole domain of interest. In contrast, in this case, the strain components after the elastic constant change were equal to 1/R times the strain components before the elastic constant change. In this paper, the ratio of elastic constants after the change to before the change was R. The analysis showed that the strain components before and after the elastic constant changes were the same for cases where the elastic constant varied over the partial domain of interest. However, in this case, the stress components after the elastic constant change were equal to R times the stress components that developed before the elastic constant change in this partial domain. The analytical model was verified through numerical simulation with the help of ABAQUS.

Analysis of Strain Localization and Stress-strain Curve of Multi-linear Strain-softening Materials in Uniaxial Tension

Analytical solution to cavity expansion in linear softening soil

Investigation of Strain Localization in Elastoplastic Materials with Transversely Isotropic Elasticity

Analysis of Strain Localization in Porous Media with Transversely Isotropic Elasticity under Undrained Conditions

Strain Gradient Plasticity Solutions of Plastic Region Radius for a Borehole Problem

Expansion of Spherical Cavity of Strain-Softening Materials with Different Elastic Moduli of Tension and Compression

Local Arc-length Method of Strain-Softening and Nonlinear in Concrete Structure Material

Analysis and Simulation of Machining Deformation Resulting from Residual Stress

Micromechanical Modeling Of Tensile Response Of Elastic-Brittle Materials

Experimental Methodology for Obtaining the Flow Curve of Sheet Materials in a Wide Range of Strains

Simplified method to identify full von Mises stress-strain curve of structural metals

Effects of Strength Difference and Intermediate Principal Stress on Plane Strain Elastic–plastic Bending of a Curved Beam

Stability analysis of slope in strain-softening soils using local arc-length solution scheme

Analysis of Localization of Mohr-Coulomb Strength Law with Damage Effect

A Model of Undrained Stress–Strain Curves Considering Stress Path and Strain Softening

Stress–strain curves of metallic materials and post‐necking strain hardening characterization: A review

Size-dependent Nonlinear Post-Peak Stress-Strain Curve of Normal Concrete in Uniaxial Compression

Explanation of Strain Softening and Numerical Modeling to the Failure Process of Laminated Composite Material

Theoretical Solution for Stress and Strain Distributions Induced by Generalized Elastic Constant Variation in Rock Mass

Simulation of localization failure with strain-gradient-enhanced damage mechanics

A Visco-Hyperelastic Softening Model for Predicting the Strain Rate Effects of 3D-Printed Soft Wavy Interfacial Layer