Abstract:The hygric performance of building envelopes determines the degradation progress. Multiple factors, including the climate parameters (e.g., solar radiation and wind-driven rain) and building structure (e.g., thermal bridges), significantly affect the hygrothermal conditions in building envelopes. Inappropriate thermal insulation measures may exacerbate the humidity within the building envelope and further induce condensation and mould growth, which threatens the building structural safety and indoor air quality. However, the key facilitators of moisture accumulation in building envelopes are yet to be fully determined. Herein, a well-validated coupled heat and moisture transfer (HAMT) model was adopted to investigate moisture accumulation in building envelopes. The target building was located in a Chinese city (Hangzhou) where the climate is characterized as a hot and humid summer and a cold winter. The results demonstrate that the moisture content as well as condensation and mould risk is closely related to the building wall orientation. High heat flux at the exterior surface can reduce the overall moisture content of the building envelope. Conversely, it could facilitate moisture accumulation when the building envelope is exteriorly isolated by a layer of thermal insulation material (e.g., expanded polystyrene). Subsequently, the insulation layer could increase condensation risk. Three prone periods for condensation as well as spore germination and mould growth in a year were detected, indicating that the conditions that are tendentious for the above risks are the same. The adoption of an external insulation layer could prevent mould from growing inward while increasing the condensation risk. (c) 2022 Elsevier B.V. All rights reserved.

Study on Heat and Moisture Coupled Transfer for Envelope Drying Process of New Buildings

Heat and Moisture Transfer in Wall-to-floor Thermal Bridges and Its Influence on Thermal Performance

Facilitator of moisture accumulation in building envelopes and its influences on condensation and mould growth

The Moisture Distribution in Wall-to-floor Thermal Bridges and Its Influence on Mould Growth

STUDY ON THE CHANGE OF ENVELOPE HEAT TRANSFER COEFFICIENT FOR NEW COMPLETED BUILDING

Optimum Insulation Thickness of External Walls by Integrating Indoor Moisture Buffering Effect: a Case Study in the Hot-Summer-cold-winter Zone of China

Study on Energy Saving Effect of Heat-Reflective Insulation Coating on Envelopes in the Hot Summer and Cold Winter Zone

Coupled Heat and Moisture Transfer in Walls Featuring Moisture-Buffering Materials and Ventilating Layers: an Experimental Study

Study on moisture transfer in porous building components and indoor environment

Study of heat and moisture transfer in internal and external wall insulation configurations

EXPERIMENTAL INVESTIGATIONS AND NUMERICAL PREDICTIONS OF HUMIDITY STATE OF A NEW BUILDING ENVELOPE

Simulation on Coupled Heat and Moisture Transfer for EPS Plates Thin Plaster External Wall Systems

Simulation On Heat Transfer Of Drywalls With Phase Change Capsules In Building Envelopes

Study on Field Test Method of Heat Transfer Cofficient of Existing Building Envelope

The Analysis of Coupled Heat and Moisture Transfer in Building Envelop Based on Numerical Simulation

Study on Heat and Moisture Transfer Characteristics of HPCMs

Heory Analysis and Modeling of Drying System Honeycomb Paperboard Based on Heat Transfer

SIMULATION OF HEAT TRANSFER OF PHASE CHANGE DRYWALLS IN PASSIVE SOLAR BUILDING ENVELOPES

INVESTIGATION OF COUPLED HEAT AND MOISTURE TRANSFER IN MULTI-WALL UNDER PERIODIC BOUNDARY CONDITIONS

Thermal Performance of a New Ventilated Concrete Envelope

Simulation of Coupled Heat and Moisture Transfer in Air-Conditioned Buildings