Abstract:The experiment was carried out on the test loop HRTL-5,which simulates the geometry and system design of a 5 MW Nuclear heating reactor. The analysis was based on a one-dimensional two-phase flow drift model with conservation equations for mass, steam mass, energy and momentum. Clausius-Clapeyron equation was used for the calculation of flashing front in the riser. A set of ordinary equation, which describes the behavior of two-phase flow in the natural circulation system, was derived through integration of the above conservation equations in subcooled boiling region,bulk boiling region in the heated section and in the riser. The method of time-domain was used for the calculation. Both static and dynamic results are presented. System pressure, inlet subcooling and heat flux are varied as input parameters. The results show that, firstly, subcooled boiling in the heated section and void flashing in the riser have significant influence on the distribution of the void fraction, mass flow rate and stability of the system, especially at lower pressure, secondly , in a wide range of two-phase flow conditions, only subcooled boiling occurs in the heated section. For the designed two-phase regime operation of the 5 MW nuclear heating reactor, the temperature at the core exit has not reaches its saturation value. Thirdly, the mechanism of two-phase flow oscillation, zero-pressure-drop , is described. In the wide range of inlet subcooling (0 KAT28 K) there exists three regions for system flow condition, namely, (1) stable two-phase flow, (2) bulk and subcooled boiling unstable flow, (3) subcooled boiling and single phase stable flow. The response of mass flow rate, after a small disturbance in the heat flux, is showed in the above inlet subcooling range, and based on it the instability map of the system is given through experiment and calculation.

The calculation of void fraction along the axial direction under HRTL-5 condition

A Mathematic Model of Two-Phase Flow Taking Account of Sub-Cooled Boiling, Condensation, and Void Flashing

Experimental and Numerical Investigation of Sub-Cooled Boiling, Condensation, and Void Flashing in Nuclear Heating Reactor Test Loop

Determination of Parameters for Two-Phase Drift-Flow Model for Natural Circulation System of Nuclear Heat Reactor

Two-phase Flow Oscillation and Distribution in Parallel Channels During R1233zd(E) Subcooled Flow Boiling: A Numerical Study

Steady-State Behaviors of Natural Circulation in HRTL-5

Investigation of Bubble Interaction in a Temporal and Spatial Heat Flux Partitioning Model for Subcooled Flow Boiling

Theoretical Model of Two-Phase Drift Flow on Natural Circulation

Analysis on Flow Characteristic of Nuclear Heating Reactor

Bifurcation Characteristic of Two-Phase Flow in Natural Circulation System with Low Steam Quality

Thermal Hydraulic Modeling of a Natural Circulation Loop

Studies on the Subcooled Boiling in a Fuel Assembly with 5 by 5 Rods Using an Improved Wall Boiling Model

CFD simulation focusing on void distribution of subcooled flow boiling in circular tube under rolling condition

Experimental analysis on non-thermoequilibrium in a natural circulation system (2. dynamic)

Critical Heat Flux Prediction Model for Low Quality Flow Boiling

Effect of parameter in drift-model on two-phase flow analysis

CFD Calculation of Natural Convection Heat Transmission in a Three-Dimensional Pool with Hemispherical Lower Head

Analysis of Characteristic Curves for Natural Circulation Flow Excursion at Low Steam Quality Conditions

Numerical Simulation of Subcooled Boiling Water in Vertical Concentric Annulus under Low Pressure

Evaluation Analysis of Correlations for Predicting Void Fraction of Condensation Hydrocarbon Refrigerant Upward Flow in a Spiral Pipe

Numerical Study on R32 Flow Condensation in Horizontally Oriented Tubes with U-Bends