Abstract:It has been widely considered that the global warming was induced by the increasing atmospheric concentrations of carbon dioxide, which has a significant impact on the sustainable development of the human society. Injecting carbon dioxide into depleted oil / gas reservoir has been developed to reduce carbon dioxide emission by the sequestration of CO2 underground, which is also considered as one promising approach to enhance oil recovery simultaneously. The evaluating of CO2 sequestration in oil reservoir needs highly accurate experimental data and models about the thermodynamic characters of CO2 + oil mixture. Density is one of key physical characters for simulating the diffusion and migration of carbon dioxide under the oil / gas reservoir. Research on volumetric behaviour is helpful to understand the expansion of the liquid phases in CO2 + oil mixture.In this paper, decane is investigated instead of petroleum because of the similar thermal physical property. The measurements have been performed at pressures from 12 MPa to 18 MPa and temperatures from 313.15 K to 343.15 K at four compositions x(1) (x(1) is the mole fraction of carbon dioxide) = 0.8690, 0.9135, 0.9430 and 0.9818 by a magnetic suspension balance (MSB). The accuracy of the experimental quantities presented in this work are T / K = +/- 0.01, m / g = +/- 10(-5) respectively. One circulation pump (AKICO, Japan) is equipped to accelerate the dissolution of CO2 in decane. Some conclusions can be obtained from the experiment as follow: (1) the dissolution of CO2 increases the density of decane, the density of CO2 + decane solution increases with increasing pressure and decreases with increasing temperature. (2) the slope of density with respect to pressure increases with increasing CO2 mole fractions while the slope with respect to temperature decreases with increasing CO2 mole fractions. (3) the crossover phenomenon appears at different compositions and the crossover pressure increases with temperature. (4) the excess molar volumes of this binary mixture are negative and show negative increasing with temperature for the data reported in this work. The GERG - 2008 model is used to predict density of CO2 + decane solution, which takes temperature, pressure, and CO2 concentration into account. An empirical equation is also used to predict the density of this binary mixture. The predictions show that the empirical equation is in good agreement with the experimental data over the experimental range. The measurement and the model used in this work supplies the basic experimental data and theoretical analysis to CO2 sequestration and enhance oil recovery. (C) 2013 The Authors. Published by Elsevier Ltd.

Study of density properties of supercritical CO2-decane solution using magnetic suspension balance

Research and performance evaluation of CO2 solubilization synergist for heavy oil

Densities And Excess Volumes Of Co2 + Decane Solution From 12 To 18 Mpa And 313.15 To 343.15 K

Density Measurements of Supercritical CO2 + Dagang Brine for CO2 Geological Storage ☆

Measurement and Modeling of the Densities for Co2 + Dodecane System from 313.55 K to 353.55 K and Pressures Up to 18 Mpa

Molecular Dynamics Study on the Diffusion Mass Transfer Behaviour of CO2 and Crude Oil in Fluids Produced via CO2 Flooding

Molecular Insights into CO2 Diffusion Behavior in Crude Oil

Densities and Volumetric Characteristics of Binary System of CO2 + Decane from (303.15 to 353.15) K and Pressures Up to 19 MPa

Study of Supercritical State Characteristics of Miscible CO2 Used in the Flooding Process

Research Progress Of The Interfacial Tension In Supercritical Co2-Water / Oil System

Density of Carbon Dioxide + Brine Solution from Tianjin Reservoir under Sequestration Conditions

Integration of a fused silica capillary and in-situ Raman spectroscopy for investigating CO 2 solubility in n -dodecane at near-critical and supercritical conditions of CO 2

Study on the solubility parameter of supercritical carbon dioxide system by molecular dynamics simulation

Experimental study on the CO2-decane displacement front behavior in high permeability sand evaluated by magnetic resonance imaging

Density measurement and equal density temperature of CO 2 +brine from Dagang — formation from 313 to 363 K

Laboratory Study on the Oil Displacement Process in Low-Permeability Cores with Different Injection Fluids

(P, Ρ, T) Behavior of CO2 + Tetradecane Systems: Experiments and Thermodynamic Modeling

The Experiment of CO(2) Solubility in Crude oil and NaCl Solution

Molecular Dynamics Simulations Study on the Shear Viscosity, Density, and Equilibrium Interfacial Tensions of CO2 + Brines and Brines + CO2 + n-Decane Systems

Molecular Simulation Study on the Density Behavior of n -Alkane/CO 2 Systems

Experimental Study on CO2 Diffusion in Bulk N-Decane and N-Decane Saturated Porous Media Using Micro-Ct