Abstract:Photoanodes based on semiconductor WO3 have been attractive due to its good electron mobility, long hole-diffusion length, and suitable valence band potential for water oxidation. However, the semiconductor displays disadvantages including a relatively wide bandgap, poor charge separation and transfer, and quick electron-hole recombination at the interface with the electrolyte. Here we present a significantly improved photoanode with a tandem structure of ITO/WO3/Cu2O/CuO, which is prepared first by hydrothermally growing a layer of WO3 on the ITO surface, then by electrodepositing an additional layer of Cu2O, and finally by heat-treating in the air to form an exterior layer of CuO. Photocurrent measurements reveal that the prepared photoanode produces a maximum current density of 4.7 mA cm-2, which is, in comparison, about 1.4 and 5.5 times the measured values for ITO/WO3/Cu2O and ITO/WO3 ones, respectively. These enhancements are attributed to (1) harvested UV, visible, and NIR light of the solar spectrum, (2) accelerated charge separation at the heterojunction between WO3 and Cu2O/CuO, (3) better electrocatalytic activity of formed Cu x O than pure Cu2O, (4) formation of a protective layer of CuO. This study thus may lead to a promising way to make high-performance and low-cost photoanodes for solar energy harvesting.

Preparation and characterization of a novel WO_3/W photoanode

Preparation of well-aligned WO 3 nanoflake arrays vertically grown on tungsten substrate as photoanode for photoelectrochemical water splitting

Facile Fabrication of Sandwich Structured WO3 Nanoplate Arrays for Efficient Photoelectrochemical Water Splitting.

Facile Synthesis of Tungsten Oxide Nanostructures for Efficient Photoelectrochemical Water Oxidation

Seed Layer-Free Hydrothermal Synthesis of Porous Tungsten Trioxide Nanoflake Arrays for Photoelectrochemical Water Splitting.

Ultrafast fabrication of nanostructure WO 3 photoanodes by hybrid microwave annealing with enhanced photoelectrochemical and photoelectrocatalytic activities

Wo3 Nanoflakes for Enhanced Photoelectrochemical Conversion

Novel Nanostructured WO 3 @Prussian Blue Heterojunction Photoanodes for Efficient Photoelectrochemical Water Splitting

In situ integration of cocatalyst and heterojunction to WO3 photoanode with enhanced photoelectrochemical performance via phosphatization

Preparation and Photoelectrochemical Properties of Nano-Porous Tungsten Trioxide Films Electrode

Preparation and Photoelectrocatalytic Properties of WO<sub>3</sub>/Pt Composite Film

A facile two-step method for fabrication of plate-like WO3 photoanode under mild conditions.

Boosting Light Harvesting and Charge Separation of WO3 Via Coupling with Cu2O/CuO Towards Highly Efficient Tandem Photoanodes.

ALD-based hydrothermal facile synthesis of a dense WO<sub>3</sub>@TiO<sub>2</sub>-Fe<sub>2</sub>O<sub>3</sub> nanodendrite array with enhanced photoelectrochemical properties

Epitaxial growth of WO3 nanoneedles achieved using a facile flame surface treatment process engineering of hole transport and water oxidation reactivity

3D hierarchical WO3 grown on TiO2 nanotube arrays and their photoelectrochemical performance for water splitting

Facile preparation of nanoflower structured WO3 thin film on etched titanium substrate with high photoelectrochemical performance

Photoelectrochemical and physical properties of WO3 films obtained by the polymeric precursor method

Epitaxial growth of WO3 nanoneedles by flame: engineering of hole transport and water oxidation reactivity

Synthesis of WO3 nanostructures and their ultraviolet photoresponse properties

Band Gap Modulation of Nanostructured WO3 Nanoplate Film by Ti Doping for Enhanced Photoelectrochemical Performance