Abstract:To study the failure of conventional packers in the fracturing and stimulation of low-porosity and low-permeability reservoirs and reduce the failure accidents of packers in the fracturing process, a suitable integrated string packers was selected in the process of fracturing and stimulation in an oilfield in the Middle East as a case study. Three different well types have been established. The wellbore temperature distribution and the axial force of the string can be calculated under the conditions of various wellhead pressures and different displacement, and it is found that the temperature at the bottom of the well can reach 130 °C, and the maximum axial force at the wellhead is 500 kN. At the same time, the applicability of retrievable tubing testing squeeze (RTTS) and hydraulic-set retrievable (RH) packer in different working conditions was evaluated, and it was found that only RTTS packers can meet the needs of the oil field. According to the calculated temperature field and axial force distribution, the stress on different components of the packer under different working conditions is established during the fracturing-stimulation operation. In the worst working conditions, the maximum stress of the packer occurs at the lower part of the central pipe, reaching 303.83 MPa, which is in a safe state. The contact stress on rubber rings can reach 30 MPa, indicating that the sealing performance can meet the requirements of on-site use. The temperature and axial force data calculated by the model provide a theoretical basis for safe well control. Through model evaluation, it was found that the RTTS packer can be suitable for the fracturing and stimulation needs of the oilfield. The research methods and achievements in the article provide theoretical guidance for evaluating the applicability of packers in the fracturing and stimulation process of low porosity and low permeability reservoirs.

A Study on Contact Stress of Packer Slip

Stresses Developed Around Displacement Piles Penetration in Sand

Ultimate bearing capacity analysis and structural optimization of packer slip

Improved Computational Method Based Upon Slip-line Field Theory For Passive Plies For Practical Use

Modeling the Interfacial De-Bonding Behavior Between Steel Wire and Adhesive

Interfacial friction effects on sealing performances of elastomer packer

Effect of structural parameters on the setting performance of plug slips during hydraulic fracturing

Partial Slip Contact Analysis on Three-Dimensional Elastic Layered Half Space

Research on the Adaptability of Packers for Integrated String Fracturing Operations in Low Porosity and Low Permeability Reservoirs

Stress Analysis and Assessment of Stream Setting Vessel Based on Elastic Contact Element Method

Numerical Method for Solving Contact Problems under Partial Slip Conditions

Nonlinear finite element analysis on the sealing performance of rubber packer for hydraulic fracturing

Effects of Load Configuration on Partial Slip Contact Between an Elasticplastic Sphere and a Rigid Flat

Fluid-solid Coupling Analysis of the Pressure Expansion of Packers

Adaptability of hydraulic fracturing packers and optimization of their sealing performance for three common clastic rock reservoirs based on finite element analysis

Research on the Influence of Stress Relaxation on the Sealing Performance of the Packer Under HTHP

Study on the Oil Film Force with Unlimited Length Oil Film of the Sliding Bearing and the ERSFD with Bosses

Failure analysis of wellhead casing and optimization of slip hanger in ultra deep wells

Partial slip contact of materials with vertically aligned cracks near surface

Mechanical Behavior and Structure Optimization of Compressed PHP Packer Rubber

Stress Analysis on Layered Materials in Point Elastohydrodynamic-Lubricated Contacts