Abstract:Since most of the cable-driven parallel manipulators (CDPMs) are small in dimension or low in speed, the self-weight or inertia of the cable is neglected when dealing with the problems of kinematics, dynamics and workspace. The cable is treated as a massless straight line, and the inertia of the cable is not discussed. However, the camera robot is a large-span high-speed CDPM. Thus, the self-weight and inertia of the cable cannot be negligible. The curved cable due to the self-weight is modeled as a catenary to accurately account for its sagging effect. Moreover, the dynamic model of the camera robot is derived by decomposing the motion of the cable into an in-plane motion and an out-plane motion, based on which an iterative-based tension distribution algorithm and a workspace generation algorithm are presented. An optimization model is presented to simultaneously improve the workspace volume, anti-wind disturbance ability and impulse of tensions on the camera and pan–tilt device system (CPTDS) by selecting the proper optimal variables under the linear and nonlinear constraints. An improved genetic algorithm (GA) is proposed, and the simulation results demonstrate that the improved GA offers a stronger ability in global optimization compared to the standard genetic algorithm (SGA). The ideal-point method is employed to avoid the subjective influence of the designer when performing the multi-objective optimization, and a remarkable improvement of the performance is obtained through the optimization. Furthermore, the distribution characteristics of the optimization objects are studied, and some valuable conclusions are summarized, which will provide some valuable references in designing large-span high-speed CDPMs.

Application of Solution of Unstressed Cable Length to Kinematics Study for a Wire Driven Parallel Mechanism

Inverse Dynamics of a Long-span Wire Driven Parallel Robot

Analysis of the Stiffness of a Wire Driven Parallel Robot

Optimization of Cable Tensions of a Cable-Driven Parallel Manipulator for a Large Radio Telescope

Modeling and Control Study of Cable-Driven Parallel Manipulator for FAST

Kinematics Solution of Cable-Driven Parallel Robots Considering Cable Sagging*

Modeling and Control of the Feed Cable-Supporting System for Large Spherical Radio Telescope

Modeling of variable length Cable Driven Parallel Robot

Analysis and design of 3T cable-driven parallel manipulator for the feedback’s orientation of the large radio telescope

Dynamic Modeling, Workspace Analysis and Multi-Objective Structural Optimization of the Large-Span High-Speed Cable-Driven Parallel Camera Robot

Analysis and a Simplified Model of the Cable of a Large-Scale Flexible Parallel Manipulator for a Large Radio Telescope

Computed Torque Control of a Two-DOF Cable-Suspended Parallel Mechanism

Dynamic Modeling and Active Control of a Cable-Suspended Parallel Robot

Forward Kinematics Analysis and Experimental Validation of a Four-Cable-driven Under-Constrained Parallel Mechanism

Dynamic Modeling and Disturbance-rejection Control of 6-DOF Cable Driven Parallel Manipulator

Forward Kinematics Analysis and Tension Distribution of a Cable-Driven Sinking Winches Mechanism

Development of a Large Parallel‐cable Manipulator for the Feed‐supporting System of a Next‐generation Large Radio Telescope

Dynamic Analysis of Cable-Driven Parallel Manipulators with Time-Varying Cable Lengths

STIFFNESS ANALYSIS OF CABLE-DRIVEN PARALLEL MANIPULATORS USING EQUIVALENT MODEL

Finite Element Analysis And Experimental Study For Torsional Stiffness Of The Large Radio Telescope

Nonlinear Pd Control of A Long-Span Cable-Supporting Manipulator in Quasi-Static Motion