Abstract:Aiming at the problem of serious deviation from the actual energy consumption for the calculated energy consumption with the continuous operation mode prescribed in current design standard for residential building energy efficiency in hot summer and cold winter zone, a questionnaire survey for the use mode of air conditioner has been conducted in Hangzhou, a typical city in this climate zone. It was found that there widely exists intermittent energy consuming method in the residential buildings of this area. The air conditioning using behavior was affected by thermal feeling of human body. The greater the indoor air temperature deviates from the the human body comfort scope, the higher the air conditioning opening rate is. DeST was employed to calculate the annual energy consumption of the residential building with internal and external wall insulations under different occupant behaviors, and then the annual energy saving effects were analyzed. The results show that in continuous energy consuming method, the annual energy saving effect for external insulation is better than that for internal insulation;in intermittent energy consuming method without considering tolerate temperature, the annual energy saving effect for internal insulation is better than that for external insulation. Under the condition of variable tolerate temperature, the critical tolerate temperature point for internal and external insulation with the same energy saving effect is 31.8 ℃ in summer and 13.4 ℃ in winter. When tolerate temperature is lower than the critical point, the internal insulation has better energy saving effect; when tolerate temperature is higher than the critical point, the external insulation has better energy saving effect. The choice of reasonable insulation means in this region was greatly affected by the air?conditioning behaviors and occupants’ thermal tolerance. The critical tolerate temperature for the same energy saving of the internal and external insulations is 31.8℃ in summer and 13.4℃ in winter. Therefore, setting reasonable air?conditioning behavior in the design standard for energy efficiency is an important premise for accurately evaluating the energy saving effect of exterior wall insulation measures.

Influence of User Room Location in Residential Building on Metered Heat

Energy Efficiency For Airtightness And Exterior Wall Insulation Of Passive Houses In Hot Summer And Cold Winter Zone Of China

Influence on energy saving effects of internal and external wall insulations for different occupant behaviors

Effect of Inhabitant Behavioral Responses on Adaptive Thermal Comfort under Hot Summer and Cold Winter Climate in China

Economic Analysis of Energy-Saving Renovation Measures for Urban Existing Residential Buildings in China Based on Thermal Simulation and Site Investigation

Life Cycle Assessment of Residential Heating Systems: A Comparison of Distributed and Centralized Systems

On-site Measured Summer Indoor Environment in Residential Buildings in Hangzhou Based on Architectural Typology

Influencing Factors on Infiltration Rate of Heating Rooms in Hot Summer and Cold Winter Zone

Thermal Characteristics and User Regulation of Household Heat Metering for Residential District Heating Systems in Northern China

Method of Defining Heating and Cooling Period for Residential Buildings in Hot Summer and Cold Winter Zone

Influence of ventilation-behavior during off-periods on energy-consumption for an intermittently heated room of dormitory buildings

Impact Analysis of Urban Morphology on Residential District Heat Energy Demand and Microclimate Based on Field Measurement Data

Numerical simulation of the influencing factors of radiant floor heating system

Monitoring and Analysis of Heat Emission of Domestic Hot-water Pipe Network in Student Villages of Zhejiang University

MEASUREMENT AND FIELD SURVEY OF THERMAL ENVIRONMENT IN CENTRAL HEATING ROOMS

Evaluating the Influence of Different Layouts of Residential Buildings on the Urban Thermal Environment

Characterization Of District Heating Energy Use Of A Typical Residential Building In North China

Adjacent heat transfer characteristics and energy efficiency optimization in university classrooms under partial-space heating by a numerical model based on field test

Dynamic local heating performances of typical heating terminals: Evaluation and comparison based on heat matching coefficient

Occupant-centric dynamic heating demand in residential buildings based on a temporal-spatial combined quantification method

Study on Simulation Method of Heating and Air-conditioning Energy Consumption of Residential Buildings