Abstract:With the proliferation of RFID-enabled applications, multiple RFID readers (or reader antennas) must be used to provide full coverage to any deployment area beyond the communication range of a single reader. However, reader collision together with tag-to-tag collision seriously degrades the system performance or even blocks out some tags from being read. To address this problem, this paper proposes a time-efficient protocol stack that is tailored to the tag identification in a multi-reader RFID system, which consists of two protocols: one is for eliminating reader collision (RCE) and the other is for avoiding tag-to-tag collision (TCE). In RCE, we enable multiple readers to work in parallel for maximizing the number of tags to be read per unit of time. Where RCE shines is that it well addresses the problem of unbalanced load by each reader due to uneven tag distributions. Namely, in existing work, the readers with fewer tags covered will finish the tag identification earlier than other readers (with more tags). After that, these readers have to wait for all readers until they are done. This is a waste of time. The solution of RCE is to take the reader with the minimum number of tags as the reference and iteratively to update the set of concurrent readers. Besides, in TCE, we use bit-level tag response to resolve tag-to-tag collision and increase the number of useful slots, so does the read throughput. Theoretical analysis and simulation results show that the above two protocols can jointly improve the inventory efficiency and reduce the identification time by more than 50%, in comparison to the state-of-the-art. We validate TIMR’s performance by comparing its results on a real-world library data set with simulated data, demonstrating consistency across both settings.

Relay MAC: A Collision Free And Power Efficient Reading Protocol For Active RFID Tags.

Collision-Aware Churn Estimation in Large-Scale Dynamic RFID Systems.

Collision-Aware Churn Estimation in Large-Scale Dynamic RFID Systems

RollCall : the Design for A Low-Cost and Power Efficient Active RFID Asset Tracking System

Dual-Reader Wireless Protocols for Dense Active Rfid Identification

Master-slave Dual Readers Enhanced Aloha Anti-Collision Mechanism for Dense Active RFID

Efficient Misplaced-Tag Pinpointing in Large RFID Systems.

A Survey and Tutorial of RFID Anti-Collision Protocols

STEP: A Time-Efficient Tag Searching Protocol in Large RFID Systems

One More Hash Is Enough: Efficient Tag Stocktaking In Highly Dynamic Rfid Systems

Multi-hop Routing Protocols for RFID Systems with Tag-to-tag Communication

A Protocol Stack for Large-Scale RFID Systems: Mitigating Reader and Tag Collisions

Complete and Fast Unknown Tag Identification in Large RFID Systems

Fast Cloned-Tag Identification Protocols for Large-Scale RFID Systems

An Active Tag's Anti-collision MCMA Protocol of RFID Based on the Quorum System

Facilitating an Active Transmit-only RFID System Through Receiver-based Processing

Optimize the Power Consumption of Passive Electronic Tags for Anti-Collision Schemes

A Dynamic Multi-ary Query Tree Protocol for Passive RFID Anti-collision

Decoding the Collisions in Rfid Systems

Concurrent Rate-Adaptive Reading With Passive RFIDs

Cooperative Routing and Transmission over Multi-hop Network of RFID Tags.