Abstract:Constraint effect existing in the cracked structures plays a vital role in monotonic loading conditions and affects the material fracture behaviour, it is not clear whether the constraint affects the cyclic plastic responses in the cyclic loading condition. In this research, the laboratory compact tension (CT) and central-cracked tension (CCT) specimens with different in-plane and out-of-plane constraints were selected to explore the constraint effect on the ratchet limit and cyclic plastic behaviour numerically by the Linear Matching Method (LMM). The results show that the plastic shakedown load domain and low cycle fatigue (LCF) life are compressed dramatically by increasing the in-plane constraint effect, while the out-of-plane constraint effect elevates the capability to resist ratcheting failure. In addition, the ratcheting boundary of the cracked specimen is much more sensitive and vulnerable under the influence of the high in-plane constraint effect. Moreover, the unified constraint parameter Ap is suitable to measure the strength of compound constraint under cyclic loading conditions, and there is a salient linear relation between constraint parameter Ap and cyclic plastic responses (including ratchet limit and alternating plastic strain range) of the cracked specimen. This correlation is very meaningful for evaluating the ratchet limit and low cycle fatigue (LCF) life of cracked structures in terms of different levels of constraint conditions (including different in-plane, out-of-plane, and compound constraint conditions), where the constraint effect is calibrated based on the unified constraint parameter Ap.

Effects of specimen thickness, hardening and crack closure for the plastic strip model

MODELLING THE INFLUENCE OF STRAIN HARDENING AND PLASTIC CONSTRAINT ON CRACK CLOSURE OF ARBITRARILY THICK CCT-SPECIMENS

FATIGUE CRACK CLOSURE ANALYSIS UNDER TRIAXIAL STRESS CONSTRAINT

Fatigue Crack-Closure Analytical Model For Considering Thickness And Hardening Effects

Crack Tip Field in a Linear Elastic–plastic Strain-Hardening Material

The Analyses of the Three-Dimensional Stress Structure Near the Crack Tip of Mode I CT Specimens in Elastic-Plastic State (i)—the Analyses of Constraint Parameters and Fracture Parameters

Thickness Debit Effect in Ni-based Single Crystal Superalloys at Different Stress Levels

Investigation on Plastic Flow Behaviors of FCC Polycrystalline Aluminum under Pre-Cyclic Tension-Compression Loading: Experiments and Crystal Plasticity Modeling.

Effect Of Confining Pressure On Stress Intensity Factors For Cracked Brazilian Disk

Constraints on the Crack Tip Plastic Fields under Large Scale Yield

Influences of Initial Porosity, Stress Triaxiality and Lode Parameter on Plastic Deformation and Ductile Fracture

A Better Model for the Engineering Calculation of Stress Intensity Factor for Stiffener Containing Crack

A Plastic Fracture Mechanics Model for Characterization of Multiaxial Low-Cycle Fatigue

Quantification of constraint effects in elastic-plastic crack front fields

3D constraint effect on 3D fatigue crack propagation

New Constraint Parameters Based on Crack Tip Plastic Zone: Theoretical Derivations and Effectiveness Verification

THEORETICAL ANALYSIS OF FATIGUE CRACK CLOSURE CONSIDERING STRESS STATES

Effects of applied stress level on plastic zone size and opening stress ratio of a fatigue crack

Effect of Constraint on Cyclic Plastic Behaviours of Cracked Bodies and the Establishment of Unified Constraint Correlation

Mode-I Plane-Stress Crack-Tip Constraint for Elastic-Plastic Materials with Different Strain-Hardening

Analytical Characterizations of Crack Tip Plastic Zone Size for Central-Cracked Unstiffened and Stiffened Plates under Biaxial Loading