Abstract:A digital deconvolution method with pile-up reconstruction has been proposed for scintillator detectors for high rate photon-counting X-ray imaging applications. The detector signal was modeled as an exponential decay waveform convoluted with the single photon response of the SiPM detector. An impulse signal can be obtained by digital deconvolution (unfolding) with much shorter duration, which was then used for energy estimation followed by a trapezoid filter and pile-up discrimination The whole digital deconvolution algorithm has been synthesized and verified by both SIMULINK simulation and experimental tests. The prototype of the detector and the readout electronics were developed for demonstration, using 3 mm x 3 mm x 10 mm LYSO scintillator coupled with a 3 mm x 3 mm SenSL SiPM. A 14 bit, 100 MSPS ADC was used to sample the analog waveform and the digital filter was implemented in a Xilinx Kintex 7 FPGA. The signal width was shortened from similar to 250 ns to 10 similar to 20 ns and then was shaped into trapezoidal pulse with 100 ns width. The energy was estimated from the trapezoid top for better signal collection and noise rejection. The unfolded pulses were used for pile-up discrimination and to reconstruct two pile-up signals from the overlapped trapezoid outputs. The energy performance of the prototype system was firstly validated by measuring the energy spectrums of Am-241, Co-57, Na-22 and Cs-137 radiation sources. The energy resolutions were measured to be 36.9%, 29.9%, 13.9% and 12.9% respectively at 59.5 keV, 122 keV, 511 keV and 662 keV in FWHM. High rate performance was evaluated by an X-ray generator. The maximum output counting rate was measured to 5.36 Mcps without saturation, comparing with the saturated counting rate of 2.34 Mcps using the original LYSO signals The saturation counting rate using digital deconvolution was estimated to be up to similar to 7 Mcps fitted with the paralyzable dead time model, corresponding to similar to 20 Mcps input count rate.

Low Energy X-Ray Imaging Using Plastic Scintillating Fiber: A Simulation Study

MeV X-ray Imaging Using Plastic Scintillating Fiber Area Detectors: A Simulation Study

Energy-resolving large area X-ray imaging enabled by stacked metal halide scintillators

Some Characteristics of X-Ray Imaging for Energy Region of over 100 Kev Using Plastic Scintillation Fiber Array

Possibility Analysis about Imaging Using Plastic Scintillating Fiber Array for High-Energy Incident Beam

Sensitivity of plastic scintillating fiber optic for X and γ radiation, a simulation study

A Simulation Study of the DQE of a Linear Plastic Scintillating Fiber Array for Hard Gamma-Rays

Monte-Carlo Simulation for Determining SNR and DQE of Linear Array Plastic Scintillating Fiber

Simulation Study of Energy Absorption of X- and $\Gamma$-Rays in Plastic Scintillating Fiber Arrays

Simulation study on detection efficiency of plastic scintillating fiber under γ-ray radiation

X-ray Sensor Based on Pixelated Scintillation Film on Photodiode Arrays

X-ray imaging using a single plastic scintillating fiber

Experimental study of plastic scintillators array for compact fast neutron-gamma dual-modality imaging system

Position-sensitive plastic scintillator detector with WLS-fiber readout

X-Ray Detector-on-Plastic With High Sensitivity Using Low Cost, Solution-Processed Organic Photodiodes

Simulation study of the light collection efficiency and the dependency on position resolution in plastic scintillator-based muography detectors

On reachable energy resolution of SiPM based scintillation counters for X-ray detection

Congruent Glass Composite Scintillator for Efficient High‐Energy Ray Detection

Experimental results using a hybrid silicon pixel detector for scintillating fibre readout and X-ray imaging

Digital Deconvolution Of Scintillation Detector Signals For High Rate Photon-Counting X-Ray Imaging Applications