Abstract:Pulsed power technology has traditionally served in the field of defense technology and is generally operated in a single operation. With the increasing demand in the military and high-energy physics fields, especially in the fields of medicine [1], industry, environmental protection and electromagnetic interference, the demand for high average power is becoming more and more urgent, requiring the pulse source to be in a high repetition frequency operating state. The high-repetition-frequency high-voltage pulse source is a pulse power system that can operate at high repetition frequencies and generate high voltage pulses. Ultra-wideband electrical pulse sources with small size and all solid-state structures are easier to integrate into the system and compatible with other devices. This paper introduces the design and implementation of a high-repetition-frequency high-voltage pulse generating device. The device is mainly composed of a pulse signal source module, a power amplification module and a pulse compression module. The article describes in detail about the pulse signal generation module based on MCU (micro-controller unit) and FPGA (field programmable gatearray) with adjustable frequency adjustable pulse width at the source level, the pulse signal power amplification module based on DSRD (drift step recovery diode) [2] switch, the pulse compression module based on the principle of diode reverse recovery. The final test results show that the device can work at 1MHz repeat frequency, the output pulse peak voltage can be up to 1700V on 50 Omega load, the output pulse rising edge is less than 1 ns, and the half pulse width is up to 1.9 ns. If the pulse compression module is connected, the half pulse width can reach 1.56 ns and the compression ratio can reach 87%.

Design and Implementation of a High-Speed Gate Pulse Generator for Image Intensifier

An Efficient, Repetitive Nanosecond Pulsed Power Generator with Ten Synchronized Spark Gap Switches

Theoretical and Experimental Investigation of Gating Performance of Subnanosecond Image Intensifier with Microstrip Photocathode

The Design of Fast Pulse Power Generator with Low Voltage

A Driving Pulse Edge Modulation Technique and Its Complex Programming Logic Devices Implementation.

Design and Simulation of a Compact Sub-Nanosecond Pulse Generator Based on Marx's Circuit Theory of Field-Effect Transistors

Design of Q-switching High Voltage Pulse Generators with Nanosecond Rise Time

Development of P-C Switch with Adjustable Gap

Nanosecond High Voltage Pulse Generator for Biological and Biomedical Application

Design and Construction of a Compact Portable Pulsed Power Generator

An overvoltage driver with inductive adder pulse for fast switching of series-connected MOSFETs module

A High-speed High-voltage Pulse Generator with Adjustable Falling Slope Based on Programable Multi Narrow Pulses Drive Method for Series MOSFETs

Design of Program Generating Pulse with High-speed and High-Voltage

A Compact Series-Connected SiC MOSFETs Module and Its Application in High Voltage Nanosecond Pulse Generator

Optical gating characteristic time of measurement with 20 picoseconds resolution for an ultrafast image intensifier

An Isolated Gate-Drive Method for Series MOSFETs in a Wide Adjustable Pulsewidth Range

A Technique on Driving-pulse Edge-modulation and Its Application in Reducing the Switching Voltage Spike of Power Electronic Device

Design of High Speed Gate Driver Employing IZO TFTs.

Optimization of the threshold voltage of an image intensifier in ultra-fast photocathode gating

Design of a High Speed Electro-optic Q-switch Circuit for Aerospace Applications

Design, Implementation And Analysis Of Solid-State Megahertz Continuous High-Repetition-Frequency High-Voltage Pulse Source