Abstract:In order to enhance the physical basis of the mass transfer model in numerical simulation of gas-liquid direct contact condensation and improve the fidelity, a set of methods and models are developed. Based on the concept of the piecewise-linear interface calculation (PLIC), an interface reconstruction algorithm is proposed to calculate the interfacial area concentration in three-dimensional non-orthogonal structured grids. The actual interface in the cell is replaced by a plane, whose position is determined iteratively to satisfy the local volume fraction and orientation of the actual interface. The area of the polygonal cut by the plane is taken as the interfacial area in the cell. The proposed algorithm is validated by calculating the surface area of a series of basic geometries. Obvious superiority of the proposed algorithm over the traditional models (gradient model and algebraic model) is seen. Then, the reconstructed area is used to determine the interfacial area concentration in the thermal phase change model. The process is implemented by ANSYS Fluent user-defined functions. The Stefan problem and steam bubble condensation experiment are used to test the performance of the developed methods and models. The simulation results agree well with the theoretical and experimental results with the quantitative relative errors no more than 4.3 % and 15 %, respectively. The oxygen jets condensation experiments are also used as test cases. The primary dominant frequencies predicted by the simulations are 163.01 Hz and 131.65 Hz, which agree well with the 139.72 Hz and 125.75 Hz in the experiments. The relative errors are only 17 % and 4.7 %. The unstable flow pattern of oxygen jet in liquid oxygen crossflow is explained based on the dynamic characteristics of turbulence, heat and mass transfer. The periodic variation of mass transfer rate is considered as the cause of condensation oscillation. The method for calculating the interfacial area proposed in this paper can serve as an optional and practical improvement to the numerical simulation of direct contact condensation.

An Integrated Model for Interaction Between Melt Flow and Non-Equilibrium Solidification in Thermal Spraying

A Volatile Spray Zone Model and Experimentation in a Gas-Solid Fluidized Bed with Liquid Injection

Phase Field Simulation for Non-Isothermal Solidification of Multicomponent Alloys Coupled with Thermodynamics Database

Numerical Simulation of the Melting of Solid Particles in Thermal Convection with a Modified Immersed Boundary Method

An Integrated Model for Dendritic and Planar Interface Growth and Morphological Transition in Rapid Solidification

Thin liquid film flow and heat transfer under spray impingement

An Enhanced Phase Field Model for Micron-Scale Droplet Impact with Solidification Microstructure Formation

Modeling and numerical studies of selective laser melting: Multiphase flow, solidification and heat transfer

Numerical Modeling Of Phase-Change And Heat-Transfer During Rapid Solidification Processes - Use Of Control Volume Integrals With Element Subdivision

A volume-averaged two-phase model for transport phenomena during solidification

An Integrated Multiscale Model to Study the Marangoni Effect on Molten Pool and Microstructure Evolution

Numerical simulation of nucleation, solidification, and microstructure formation in thermal spraying

Numerical Simulation of Molten Jet Breakup by Coupled Multiphase Model Based on VOF Method and Two-Fluid Model

A consistent diffuse-interface model for two-phase flow problems with rapid evaporation

Modeling of Nonequilibrium Surface Melting and Resolidification for Pure Metals and Binary Alloys

New model for PCM melting and solidification processes simulation

Rapid Solidification in Thermal Spray Deposition: Microstructure and Modelling

A multiscale nonequilibrium model for melting of metal powder bed subjected to constant heat flux

A Coupled Vaporization Model Based on Temperature/species Gradients for Detailed Numerical Simulations Using Conservative Level Set Method

A novel smoothed particle hydrodynamics formulation for thermo-capillary phase change problems with focus on metal additive manufacturing melt pool modeling

Development of a modified thermal phase change model based on the interfacial area concentration determined by an interface reconstruction algorithm