Abstract:To study the flexural behavior of prestressed concrete beams with high-strength steel reinforcement and high-strength concrete and improve the crack width calculation method for flexural components with such reinforcement and concrete, 12 specimens were tested under static loading. The failure modes, flexural strength, ductility, and crack width of the specimens were analyzed. The results show that the failure mode of the test beams was similar to that of the beams with normal reinforced concrete. A brittle failure did not occur in the specimens. To further understand the working mechanism, the results of other experimental studies were collected and discussed. The results show that the normalized reinforcement ratio has a greater effect on the ductility than the concrete strength. The cracking- and peak-moment formulas in the code for the design of concrete (GB 50010-2010) applied to the beams were both found to be acceptable. However, the calculation results of the maximum crack width following GB 50010-2010 and EN 1992-1-1:2004 were considerably conservative. In the context of GB 50010-2010, a revised formula for the crack width is proposed with modifications to two major factors: the average crack spacing and an amplification coefficient of the maximum crack width to the average spacing. The mean value of the ratio of the maximum crack width among the 12 test results and the relative calculation results from the revised formula is 1.017, which is better than the calculation result from GB 50010-2010. Therefore, the new formula calculates the crack width more accurately in high-strength concrete and high-strength steel reinforcement members. Finally, finite element models were established using ADINA software and validated based on the test results. This study provides an important reference for the development of high-strength concrete and high-strength steel reinforcement structures.

Discussion on Load-induced Crack Control for Reinforced Concrete Members

INCORPORATING PRE-EXISTING CRACKS IN STRUCTURAL ASSESSMENT OF RC STRUCTURES

Experimental Investigation on First Crack Strength and Crack Widthof Reinforced Concrete Beamsby Side-Bonding Cfrp Sheets

Crack Width Calculation Methods Of Reinforced Concrete Beidges And Application

Crack Width Calculation Methods of Reinforced Concrete Bridges and Application of Box Girder Bridge

Crack Propagation and Flexural Behaviour of Rc Beams under Simultaneous Sustained Loading and Steel Corrosion

INFLUENCE OF CRACKING WIDTH TO CONCRETE DURABILITY

Impact of crack control width on degradation and maintenance cost of flexural reinforced concrete members in chloride environment

Study on flexural performance of cracked RC beams retrofitted with CFRP sheets

Crack shape and rust distribution in corrosion-induced cracking concrete coupled with load

Numerical Analysis for Crack Width of Reinforced Concrete Beam with Bond-Slip Effect

Allowance of Concrete Crack Width Based on Durability of Domestic and Overseas Code

Cracking Behavior of Cfrp Laminate-Strengthened Rc Beams with Premechanical and Postmechanical Environmental Damage

Spatial behavior and strengthening analysis of fabricated PC hollow slab beam bridge with hinge joints

Flexural behavior of high-strength, steel-reinforced, and prestressed concrete beams

Calculation Method and Experimental Research for Crack Width in RC Single Column Piers

Design of foundation structures of sea-crossing bridges on serviceability limit state

Experiment for flexural behavior of HRB 500 rebar reinforced concrete beam under serviceability state

Study on Reliability of the Maximum Crack Width for Flexural Members of Reinforced Concrete Bridges

Mechanical properties and numerical simulation of crack interface in reinforced concrete

Deflection and Crack Calculation of Corroded Reinforced Concrete Beams