Evaluation of the Performance of Low-Cost Air Quality Sensors at a High Mountain Station with Complex Meteorological Conditions
Hongyong Li,Yujiao Zhu,Yong Zhao,Tianshu Chen,Ying Jiang,Ye Shan,Yuhong Liu,Jiangshan Mu,Xiangkun Yin,Di Wu,Cheng Zhang,Shuchun Si,Xinfeng Wang,Wenxing Wang,Likun Xue
DOI: https://doi.org/10.3390/atmos11020212
IF: 3.11
2020-01-01
Atmosphere
Abstract:Low-cost sensors have become an increasingly important supplement to air quality monitoring networks at the ground level, yet their performances have not been evaluated at high-elevation areas, where the weather conditions are complex and characterized by low air pressure, low temperatures, and high wind speed. To address this research gap, a seven-month-long inter-comparison campaign was carried out at Mt. Tai (1534 m a.s.l.) from 20 April to 30 November 2018, covering a wide range of air temperatures, relative humidities (RHs), and wind speeds. The performance of three commonly used sensors for carbon monoxide (CO), ozone (O3), and particulate matter (PM2.5) was evaluated against the reference instruments. Strong positive linear relationships between sensors and the reference data were found for CO (r = 0.83) and O3 (r = 0.79), while the PM2.5 sensor tended to overestimate PM2.5 under high RH conditions. When the data at RH >95% were removed, a strong non-linear relationship could be well fitted for PM2.5 between the sensor and reference data (r = 0.91). The impacts of temperature, RH, wind speed, and pressure on the sensor measurements were comprehensively assessed. Temperature showed a positive effect on the CO and O3 sensors, RH showed a positive effect on the PM sensor, and the influence of wind speed and air pressure on all three sensors was relatively minor. Two methods, namely a multiple linear regression model and a random forest model, were adopted to minimize the influence of meteorological factors on the sensor data. The multi-linear regression (MLR) model showed a better performance than the random forest (RF) model in correcting the sensors’ data, especially for O3 and PM2.5. Our results demonstrate the capability and potential of the low-cost sensors for the measurement of trace gases and aerosols at high mountain sites with complex weather conditions.