Abstract:Surface wear, as a major failure mode of gear systems, is an unavoidable phenomenon during the whole life of gears. It also induces other gear damages, such as fatigue cracks, surface pitting and spalling. Ultimately, those defects may result in the sudden failure of a gearbox transmission system, which can lead to a serious accident and unexpected economic loss. Therefore, it can provide huge cost and safety benefits to industries to monitor gear wear and predict its propagation. Gear wear raises the error rate of gear transmission systems, typically leading to improvements in dynamic loads, vibration, and noise. In return, the increased load conversely aggravates wear, creating a feedback cycle between dynamic responses and surface wear. For this purpose, a wear prediction model was incorporated into a tribo-dynamic model for quantitatively investigating how surface wear and gear vibration are mutually affected by each other. To obtain more precise dynamic responses, the tribo-dynamic model integrates the time-varying mesh stiffness, load-sharing ratio and friction parameters. To improve the computational efficiency and guarantee the calculation precision, an improved and updated wear depth methodology is constructed in the wear prediction model. This paper demonstrates the capability of the proposed dynamic wear prediction model in the investigation of the interaction effects between gear dynamics and surface wear, allowing for the development of improved gear wear prediction tools. The obtained results indicate that the surface wear impacts the dynamic characteristics, even with slight wear. In the initial stage of wear, the friction coefficient decreases slightly, largely due to the reduction in surface roughness; but the friction force increases because of the improved dynamic meshing force. Although the initial wear depth distributions of a pinion under dynamic and static conditions are similar, the wear depth distributions under dynamic conditions becomes significantly different compared to the those under static conditions with the wear process. The maximum wear depth of a pinion under dynamic conditions is about 1.6 times as the corresponding static conditions, when the wear cycle comes to . Similarly, the maximum accumulative wear depth of a pinion under dynamic conditions reaches 1.2 times of that under static conditions. Therefore, the proposed dynamic wear prediction model is more appropriate to be applied to the surface wear of gears.

Monitoring of the Wear Condition and Research on the Wear Process for Running Equipment

Early wear detection and its significance for condition monitoring

Modeling Wear State Evolution Using Real-Time Wear Debris Features

Condition Monitoring Approach for Wear Recognition in Gear Pump

Research on an on-line wear condition monitoring system for marine diesel engine

Wear Condition Monitoring and Working Pattern Recognition of Piston Rings and Cylinder Liners Using On-Line Visual Ferrograph

Running-in real-time wear generation under vary working condition based on Gaussian process regression approximation

Wear state identification using dynamic features of wear debris for on-line purpose

A life-cycle dynamic wear degradation model of planetary gear systems

Finite element simulation and experimental test of the wear behavior for self-lubricating spherical plain bearings

Reliability Analysis for the Dependent Competing Failure With Wear Model and its Application to the Turbine and Worm System

Study on coupling transient mixed lubrication and time-varying wear of main bearing in actual operation of low-speed diesel engine

Quantitative Prediction of Wear Failure Based on Dissipative Methodology under Dry Friction

Research on dynamic and wear prediction models of compound planetary transmission systems

A Dynamic Wear Prediction Model for Studying the Interactions between Surface Wear and Dynamic Response of Spur Gears

A FRACTURE-INDUCED ADHESIVE WEAR CRITERION AND ITS APPLICATION TO THE SIMULATION OF WEAR PROCESS OF THE POINT CONTACTS UNDER MIXED LUBRICATION CONDITION

Overview of Friction and Wear Performance of Sliding Bearings

Journal Bearing Wear Monitoring via On-Line Visual Ferrography

In-situ tool wear condition monitoring during the end milling process based on dynamic mode and abnormal evaluation

Topography Characterization of Friction Pairs During the Real-Time Wear Process in Dry Condition

Wear monitoring of bearing steel using electrostatic and acoustic emission techniques