Abstract:Distinctive temperature and stress oscillations can be observed in superelastic shape memory alloys (SMAs) when they subject to displacement-controlled cyclic phase transition. In this paper, we examine the effect of the deformation frequency on the thermal and mechanical responses of the polycrystalline superelastic NiTi rods under stress-induced cyclic phase transition. By synchronized measurement of the evolutions in overall temperature and stress–strain curve over the frequency range of 0.0004–1Hz (corresponding average strain rate range of 4.8×10−5/s–1.2×10−1/s) in stagnant air, it was found that both the temperature evolution and the stress–strain curve vary significantly with the frequency and the number of cycles. For each frequency, steady-state cyclic thermal and mechanical responses of the specimen were reached after a transient stage, exhibiting stabilization. In the steady-state, the average temperature oscillated around a mean temperature plateau which increased monotonically with the frequency and rose rapidly in the high frequency range due to the rapid accumulation of hysteresis heat. The oscillation was mainly caused by the release and absorption of latent heat and increased with the frequency, eventually reaching a saturation value. The variations in the stress responses followed similar frequency dependence as the temperature. The steady-state stress–strain hysteresis loop area, as a measure of the material׳s damping capacity, first increased then decreased with the frequency in a non-monotonic manner. The experimental data were analyzed and discussed based on the simplified lumped heat transfer analysis and the Clausius–Clapeyron relationship, incorporating the inherent thermomechanical coupling in the material׳s response. We found that, for given material's properties and specimen geometries, all such frequency-dependent variations in temperature, stress and damping capacity were essentially determined by the competition between the time scale of the heat release (i.e. the phase transition frequency) and the time scale of the heat transfer to the ambient. The results emphasize that, the two time scales of loading and heat transfer must be clearly specified when characterizing and modeling the cyclic behavior of SMA materials.

Effect of Temperature and Strain Rate on the Phase-transformation Velocity of NiTi Shape-memory Alloy

On Phase Transition Velocities of NiTi Shape Memory Alloys

Phase Transformation Behavior of Pseudoelastic Niti Shape Memory Alloys under Large Strain

Superelastic and Cyclic Response of Nitisma at Various Strain Rates and Temperatures

Atomistic Study of Temperature and Strain Rate-Dependent Phase Transformation Behaviour of Niti Shape Memory Alloy under Uniaxial Compression

Very High Strain-Rate Response of a NiTi Shape-Memory Alloy

Strain Rate Effect on the Thermomechanical Behavior of NiTi Shape Memory Alloys: A Literature Review

Experimental Study of One‐dimensional Superelastic Capability of a Nearly Equi‐atomic NiTi Shape Memory Alloy

Mechanical Response and Phase Transformation Characteristics of R-phase NiTi Shape Memory Alloy under High Strain Rate Compression

Effect of Deformation Frequency on Temperature and Stress Oscillations in Cyclic Phase Transition of NiTi Shape Memory Alloy

Effect of Plane Strain Compression and Subsequent Recrystallization Annealing on Microstructures and Phase Transformation of NiTiFe Shape Memory Alloy

Measurement of Phase Transformation Properties under Moderate Impact Tensile Loading in a NiTi Alloy

Influence of Strain Rate on Deformation Properties of TiNi Shape Memory Alloy

High Strain Rate Deformation of Martensitic Niti Shape Memory Alloy

Experimental investigation of thermomechanical behaviour of NiTi shape memory alloy under low-velocity impact loading

The Effect of Ni Content on Phase Transformation Behavior of NiTi Alloys: an Atomistic Modeling Study

Experimental Investigation on Rate Dependence of Thermomechanical Response in Superelastic NiTi Shape Memory Alloy

Influence of Strain Rate on Mechanical Properties of Shape Memory Alloy

Effect of Material State on the Phase Transformation of NiTi Shape Memory Alloy

Temperature Analysis of One-Dimensional NiTi Shape Memory Alloys under Different Loading Rates and Boundary Conditions

Observation on Rate-Dependent Cyclic Transformation Domain of Super-Elastic Niti Shape Memory Alloy