Abstract:This paper presents a novel decoupled two degrees of freedom (2-DOF) translational parallel micro-positioning stage. The stage consists of a monolithic compliant mechanism driven by two piezoelectric actuators. The end-effector of the stage is connected to the base by four independent kinematic limbs. Two types of compound flexure module are serially connected to provide 2-DOF for each limb. The compound flexure modules and mirror symmetric distribution of the four limbs significantly reduce the input and output cross couplings and the parasitic motions. Based on the stiffness matrix method, static and dynamic models are constructed and optimal design is performed under certain constraints. The finite element analysis results are then given to validate the design model and a prototype of the XY stage is fabricated for performance tests. Open-loop tests show that maximum static and dynamic cross couplings between the two linear motions are below 0.5% and -45 dB, which are low enough to utilize the single-input-single-out control strategies. Finally, according to the identified dynamic model, an inversion-based feedforward controller in conjunction with a proportional-integral-derivative controller is applied to compensate for the nonlinearities and uncertainties. The experimental results show that good positioning and tracking performances are achieved, which verifies the effectiveness of the proposed mechanism and controller design. The resonant frequencies of the loaded stage at 2 kg and 5 kg are 105 Hz and 68 Hz, respectively. Therefore, the performance of the stage is reasonably good in term of a 200 N load capacity.

Model Analysis of Air-bearing Xy-Stage with Dual-side Actuators

Design And Analysis Of Two Dimensional X-Y Micropositioning Stage

Kinematics and Inverse Dynamic Analysis of a 6 Channel Half-axle Test Rig

Modeling and Simulation of Aligning Process for Alignment Mechanism of Large Aircraft Component

Modeling of a servo platform driven by pneumatic artificial muscles

Modeling and Simulation of Flexible Multi-Body Dynamics for Large Aircraft Components Alignment Mechanism

Design and Verification of an XYZ Three-axis Micro Stage

Model Analysis of Gilling Machine

Dynamic Modeling and Analysis of a 3-DOF Ultra-precision Positioning Stage with Air Bearinga

Dynamic Analysis of Nano-precision Stage with Aerostatic Bearing

A Novel Hybrid Actuation Mechanism Based XY Nanopositioning Stage with Totally Decoupled Kinematics

Modeling and analyzing of an H-drive precision XY stage

Design, Control of an Aerostatic X-Y Planar Motion Stage for Precision Positioning

Design and Analysis of a New Flexure-Based XY Stage

Dynamic Analysis of a Gas Bearing Support Guide Way Through Simplified Beam Model

Design, optimization, and characterization of an XY nanopositioning stage with multi-level spatial flexure hinges for high-precision large-stroke motion guidance

Modeling and Analysis of Planar Multibody System Containing Deep Groove Ball Bearing with Slider-Crank Mechanism

Design and analysis of a 2-degree-of-freedom flexure-based micro-motion stage

Design and control of a decoupled two degree of freedom translational parallel micro-positioning stage

Design of a Flexure-Based XY Positioning Stage with Balanced Axial Forces on Decoupling Modules

Modeling and analyzing for ultra-precision coarse-fine stage