Abstract:A series of K-ZrO2/Cu/Al2O3 catalysts (KZC(T)A (T= 600-900 degrees C)) were prepared by a sequential impregnation method and investigated for the direct synthesis of ethanol and isobutanol from syngas. The calcination temperature for C(T)A (T= 600-900 degrees C) preparation had considerable effect on the structure and catalytic performance of KZCTA catalysts. By increasing the calcination temperature from 600 to 900 degrees C, the CO conversion was promoted obviously from 20.3 to 53.0%. When the calcination temperature was lower, KZC(700)A catalyst showed high isobutanol selectivity of 17.7 wt%, while only a small amount of isobutanol was obtained in the reference catalysts of KZA and KC(700)A without Cu or Zr as promoters. The coexistence of Cu and Zr in the catalyst was required for isobutanol formation. Furthermore, the Cu-ZrO2 interface amounts increased firstly with the increase of calcination temperature and then decreased at over-higher calcination temperature because of the aggregation of ZrO2. The isobutanol selectivity changed with the Cu-ZrO2 interface amounts in catalyst, suggesting that the Cu-ZrO2 interfaces were responsible for isobutanol preferable synthesis directly from syngas. In addition, ethanol selectivity increased clearly up to 36.3 wt% when the higher calcination temperature 900 degrees C was employed for catalyst preparation. In comparison with the KZC(900)A catalyst, the catalyst of KC(900)A prepared without Zr as promoter exhibited excellent catalytic performance for the ethanol synthesis (33.5 wt%). It revealed that Zr cannot contribute to ethanol formation, and the newly formed CuAlO2 phase under higher calcination temperature in the catalysts possibly favored ethanol formation. As confirmed by XRD, Raman spectroscopy and H-2-TPR, the CuAlO2 phase emerged and its amount increased with the increase of calcination temperature for catalyst preparation. A good linear relationship was found between ethanol selectivity and the amount of CuAlO2, proving that the CuAlO2 phase acted as efficient active sites for ethanol preferable synthesis directly from syngas.

Effect of calcination temperature on catalytic properties of Ru-Co-ZrO2/γ-Al2O3 catalysts for Ficher-Tropsch synthesis

Catalytic Performance of Alumina-Supported Cobalt Carbide Catalysts for Low-Temperature Fischer–Tropsch Synthesis

Effects of Calcination Temperature on Structure-Activity of K-ZrO2/Cu/Al2O3 Catalysts for Ethanol and Isobutanol Synthesis from CO Hydrogenation

Microcalorimetric adsorption studies of highly loaded Co-ZrO 2/SiO2 catalysts for Fischer-Tropsch synthesis

Comparison of Preparation Methods of Iron-Based Catalysts for Enhancing Fischer-Tropsch Synthesis Performance

The effects of promoters of K and Zr on the mesoporous carbon supported cobalt catalysts for Fischer-Tropsch synthesis.

Highly Efficient Fischer-Tropsch Synthesis Over An Alumina-Supported Ruthenium Catalyst

Study on Reduction Property of Cobalt Based F-T Synthesis \catalyst Supported on Alumina

Fischer–Tropsch Synthesis: Higher Oxygenate Selectivity of Cobalt Catalysts Supported on Hydrothermal Carbons

Carbon monoxide hydrogenation on Fe<sub>2</sub>O<sub>3</sub>/ZrO<sub>2</sub> catalysts

Carbon Monoxide Hydrogenation on Fe 2 O 3 /zro 2 Catalysts

Effect of Zr promoter on precipitated iron-based catalysts for high-temperature Fischer-Tropsch synthesis of light olefins

Fischer-Tropsch Synthesis: The Characterization and Testing of Pt-Co/SiO2 Catalysts Prepared with Alternative Cobalt Precursors

Effect of Calcination Conditions on Co3O4 Catalysts in the Total Oxidation of Toluene and Propane

Effect of Preparation Method and Calcination Temperature on Low-Temperature CO Oxidation over Co3O4/CeO2Catalysts

Preparation of Iron Carbides Formed by Iron Oxalate Carburization for Fischer–Tropsch Synthesis

Improved Fischer-Tropsch synthesis for gasoline over Ru, Ni promoted Co/HZSM-5 catalysts

Effect of pretreatment conditions on Fe-ZSM-5 properties and performance for Fischer-Tropsch synthesis

Effects of Calcination Temperature on the Catalytic Performance of Ni-Al2 O3 Catalyst

Effect of Synthetic Route and Metal Oxide Promoter on Cobalt-Based Catalysts for Fischer–Tropsch Synthesis

Effect of Resorcinol Formaldehyde Resin Gel on the Preparation of Co/Sio2 Catalysts for Fischer-Tropsch Synthesis