Abstract:With the successful application of spars in offshore oil and gas industry, one of the critical issues related to a spar design, the Vortex-Induced Motions (VIM), has attracted significant attention among offshore engineers. It's difficult to accurately predict the VIM responses with CFD due to insufficient understanding of the mechanism, the influence of structural configuration, the complexity of the real sea states, as well as the limitations of CFD tools. Until now, model test is still the most reliable and effective method to carry out quantitative study of VIM in order to exam the influence of the parameters such as the dimensionless amplitude; vibrating and shedding frequencies; and the reduced velocity. The 1:60 scale Truss Spar model tests have been conducted in deepwater offshore basin at State Key Laboratory of Ocean Engineering (SKLOE). The Truss Spar model consists of a hard tank with removable helical strakes, a truss section and a square soft tank. Model tests were carried out with truncated mooring system. Uniform current profiles are generated by the current generating system. In this paper, the trajectories of Truss Spar with and without helical strakes were recorded and analyzed. The heading of the model was varied from 90 to 180 degrees. The reduced velocity was from 5 to 10 and Reynolds number ranges from 1E05 to 2E05. "Figure 8" was clearly observed in the Truss Spar without strakes, while semi-circular figure was found in the strake case. Strakes suppressed VIM at all headings. The 50% decrease in amplitude for Truss Spar with strakes at the reduced velocity 8 indicates the efficiency of helical strakes on the VIM suppression. And it was found that the 120 degree heading with strakes is more effective compare to 90 and 180 degree current headings. The deduction in amplitude with strakes is at cost of increasing the drag force, in turn, resulting in the increase of offset in surge. Besides, "hot spots" phenomenon was also observed in the model test. Copyright © 2011 by the International Society of Offshore and Polar Engineers (ISOPE).

Heave Response Analysis of Truss Spar in Frequency Domain

Numerical Study on Global Motion of Truss Spar in Frequency and Time Domains for the Liwan 3-1 Area

Springing Analysis of Elastic Vessels in Head and Oblique Seas Including Nonlinear Effects Due to Second Order Diffraction Pressures

The Motion Analysis of Truss Spar Considering the Viscous Damping in Frequency Domain

Assessment of Ultimate Strength of a Typical Truss Spar Using Nonlinear Finite Element Analysis

Full Time-Domain Nonlinear Coupled Dynamic Analysis of A Truss Spar and Its Mooring/Riser System in Irregular Wave

Experimental Study on Motions and Relative Wave Elevations at Heave Plates of a Spar during Wet Tow

THEORETICAL RESEARCH ON HYDRODYNAMICS OF A GEOMETRIC SPAR IN FREQUENCY-AND TIME-DOMAINS

Global Analysis on Structural Strength of a Truss Spar Platform

A Simplified Method for Nonlinear Hydroelastic Responses of a Truss-Type VLFS in Oblique Seas Based on Orthotropic Plate Model

Effects of Heave Plate on the Hydrodynamic Behaviors of Cell Spar Platform

Experimental and Numerical Study of the Effects of Heave Plate on the Motion of A New Deep Draft Multi-Spar Platform

The Analysis of the Motion of a Geometric Spar in Deep Water

Experimental Investigation On Added Mass Coefficient Of A Truss Spar Subjected To Vortex-Induced Motions

Experimental investigation on Vortex Induced Motions of Truss Spars

The Forced Oscillation Tests on Heave Damping Plates

Experimental investigation on lift coefficient for a truss spar subjected to vortex induced motions

Numerical Study On The Hydrodynamic Behavior Of A New Cell-Truss Spar Platform

Hydrodynamic evaluation for spar platform subjected to mooring line failure

Experimental and numerical studies on the low-frequency responses of a spar-type floating offshore wind turbine

Study of Damping Ratio Identification for a Truss Spar Based on Continuous Wavelet Transform