Abstract:The flat torque-angle characteristic of torque motor plays a decisive role in the control quality of electro-hydraulic servo and proportional valve. To solve the issue that the current wet-type torque motor for two-dimensional (2D) valve does not have flat torque-angle characteristic, a method for adjusting the flat torque-angle characteristic of torque motor for 2D valve based on magnetic saturation of tooth tip is proposed. Taking the current limited angle torque motor with rectangular tooth (TM-R) as an application example, the rectangular teeth on the stator are replaced by sharp teeth to form a novel torque motor with sharp tooth (TM-S), and the flat torque-angle characteristic can be obtained by constructing magnetic saturation of tooth tip. The variation trends of magnetic permeance in each magnetic saturation region of the tooth tip are analyzed. The torque-angle characteristics of TM-S and TM-R under different control currents are compared. Prototypes of TM-S and TM-R with optimized parameters are designed and manufactured, and special experimental benches are built for static and dynamic test. Experimental results are basically consistent with the theoretical analysis. The comparative study shows that the torque-angle characteristic of TM-R is a downward curve, while the torque-angle characteristic of TM-S is an approximate flat curve. The research validates the effectiveness of the proposed method, which can both realize the flat torque-angle characteristic and improve the dynamic response of torque motor. Finally, the proposed method can be further applied to other rotary and direct-acting electro-mechanical converter (EMC) with multi-tooth structure.

The Methodology Research to Measure Angular Displacement Torque Constant of Limited-Angle Brushless Torque Motor

Virtual Torque and Rotational Speed Measuring Device

Development of a Slotless Limited-Angle Torque Motor for Reaction Wheels Torque Measurement System

Investigation on Flat Torque‐angle Characteristic of Torque Motor Based on Magnetic Saturation of Tooth Tip

Analysis, Modeling, and Verification of Limited Angle Torque Motors with Irregular Slot Numbers for Performance Improvement

Development of a Radial-Flux Slotted Limited-Angle Torque Motor with Asymmetrical Teeth for Torque Performance Improvement

Method to Measure the Torque of DC Motor in CPM Rehabilitation Apparatus

Study on Parameter Restraint and Armature Reactance of Limited Angle Torque Motor

Analysis and Simulation of a Limited-Angle Torque Motor

Precise Measurements of Magnetic Inductance in Asynchronous Motors for High Performance Applications

Quantitative Characteristic Comparison Between Sensorless Six Step and Field Oriented Control Methods for Permanent Magnet Brushless DC Motors

A Novel Indirect Measurement Method for Load Torque of Asynchronous Motor

A Novel Contactless Angular Resampling Method for Motor Bearing Fault Diagnosis under Variable Speed

Operational range extension method for limited-angle torque motors with irregular slot numbers

Development of a Limited-Angle Torque Motor with a Moving Coil

Investigation of Characteristics of a Novel Torque Motor Based on an Annulus Air Gap

Application of Noncontact Measurement Method to the Torque Measurement of Micromotors

Force Transfer Model and Characteristics of Hybrid Transducer Type Ultrasonic Motors

Research on Torque Ripple Suppression of the Slotted Limited Angle Torque Motor

A Novel Method on Real-Time Measurement of 2-DOF Motions of Spherical Ultrasonic Motor

A novel small motor measurement system based on ultrasonic bearings