Abstract:The CIE color rendering (fidelity) index (CRI) has remained unchanged for over four decades. Most, if not all, of its components could be updated to more state-of-the-art methods. One of the most critical components of any color rendering (fidelity) metric is the test sample selection. This article therefore addresses the importance of uniform sampling of wavelength space to avoid selective optimizationthat is, taking advantage of the unequal contributions of different wavelength regions to the general color rendering scoreof light source spectral power distributions. It summarizes the development of a mathematical sample set with undistorted spectral sensitivity, the HL17 set. The set is used in a recently proposed update, the CRI2012 general color rendering index. To assess the impact of the spectrally uniform sample set on color fidelity scores, the CRI2012 index values for each of a set of 139 lamps were compared with those of the CIE CRI. In addition, the impact of updating the other components was investigated. A mean and maximum absolute difference of respectively 5.9 and 21.8 index units were found between the CRI2012 and CIE CRI, although the largest partrespectively 4.03 and 19.7 index unitswas shown to be the result of updating the color difference engine and the switch to the CIE 10 degrees observer. The analysis also indicated possible past spectral selective optimization of some warm-white tri-band fluorescent sources for high luminous efficacy of radiation (LER) and (just) sufficient CIE R-a values by taking advantage of the spectral nonuniformity of the CIE reflectance set. Adopting a spectrally uniform sample set in a color rendering metric therefore has important practical implications when designing light source spectra. Finally, possible updates and further improvements of the CRI2012 are briefly mentioned.

The Method of Color Quality Evaluation of White Light LED

Evaluation of LED Sources Based on Colour Appearance Data

Evaluation of Light Sources Based on Visual Colour Rendering

Novel Measurement System and Analytical Method for White LED Phosphors

The CRI2012 Color Fidelity Index and Its Practical Application

Toward a Replacement of the CIE Color Rendering Index for White Light Sources

Wavelength Dependence of Colorimetric Properties of Lighting Sources Based on Multi-Color LEDs

Evaluation of the CIE colour rendering index: Evaluation of the CIE colour rendering index

Quantifying the suitability of CIE D50 and a simulators based on LED light sources

Experiment Validation of Color Rendering Index Based on Color Fidelity

Comparing The Quality Of The Led Based And Conventional Cie Illuminant Simulators

A new method for quantifying colour rendering A NEW METHOD FOR QUANTIFYING COLOUR RENDERING

The Quality of Light Sources

Methods for Assessing the Colour Fidelity of Light Sources

A Brief Review of Colour Quality Assessments of LED Lightings for Museums

Unique hue correction applied to the color rendering of LED light sources

Quality of LED Based Daylight Simulators

LED Light with Enhanced Color Saturation and Improved White Light Perception.

Introduction of CRI 2012 and Its Influence on Color Rendering Evaluation

Study on a system for LED's photometric and colorimetric measurement based on a multi-channel spectrometer

Considerations in LED Spectral Design for Enhanced Color Quality