Abstract:This article presents a review of the research into gas stirring in ladle metallurgy carried out over the past few decades. Herein, the physical modeling experiments are divided into four major areas: (1) mixing and homogenization in the ladle; (2) gas bubble formation, transformation, and interactions in the plume zone; (3) inclusion behavior at the steel–slag interface and in the molten steel; and (4) open eye formation. Several industrial trials have also been carried out to optimize gas stirring and open eye formation. Approaches for selecting criteria for scaling to guarantee flow similarity between industrial trials and physical modeling experiments are discussed. To describe the bubble behavior and two-phase plume structure, four main mathematical models have been used in different research fields: (1) the quasi-single-phase model, (2) the volume of fluid (VOF) model, (3) the Eulerian multiphase (E–E) model, and (4) the Eulerian–Lagrangian (E–L) model. In recent years, the E–E model has been used to predict gas stirring conditions in the ladle, and specific models in commercial packages, as well as research codes, have been developed gradually to describe the complex physical and chemical phenomena. Furthermore, the coupling of turbulence models with multiphase models is also discussed. For physical modeling, some general empirical rules have not been analyzed sufficiently. Based on a comparison with the available experimental results, it is found that the mathematical models focusing on the mass transfer phenomenon and inclusion behaviors at the steel-slag interface, vacuum degassing at the gas–liquid interface, dissolution rate of the solid alloy at the liquid–solid interface, and the combination of fluid dynamics and thermodynamics need to be improved further. To describe industrial conditions using mathematical methods and improve numerical modeling, the results of physical modeling experiments and industrial trials must offer satisfactory validations for the improvement of numerical modeling.

Modeling the Discontinuous Liquid Flow in a Blast Furnace

Influences of Scaffold and Coal Injection on Gas and Liquid Flow Distributions in Blast Furnace: Mathematical Model

Modeling Framework for the Simulation of an Electric Smelting Furnace Considering Freeze Lining Formation

Three-Dimensional Modeling of an Ironmaking Blast Furnace with a Layered Cohesive Zone

Mathematical Modeling on the Multiphase Flow during Top–Bottom Combined Blowing Basic Oxygen Furnace Steelmaking Process

Comprehensive Numerical Modeling of Raceways in Blast Furnaces

Modeling Freeze‐Lining Formation: A Case Study in the Slag Fuming Process

Computational Fluid Dynamics Simulation of Gas–Matte–Slag Three-Phase Flow in an ISASMELT Furnace

Numerical Simulation of the Interaction Between Supersonic Oxygen Jets and Molten Slag–Metal Bath in Steelmaking BOF Process

Review on Modeling and Simulation of Blast Furnace

Numerical Simulation of Blast Furnace Hearth Maintenance Measures

Numerical Simulation of Bubble and Velocity Distribution in a Furnace

Three-dimensional modelling of the wall heat transfer in the lower stack region of a blast furnace

Mathematical simulation of two-phase flow and slag entrainment during steel bloom continuous casting

Numerical simulation of flow characteristics of side-bottom combined blowing in iron bath reactor

An Integrated Model for Interaction Between Melt Flow and Non-Equilibrium Solidification in Thermal Spraying

A Review of Physical and Numerical Approaches for the Study of Gas Stirring in Ladle Metallurgy

Computational modeling of pulverized coal combustion processes in tangentially fired furnaces

Numerical Analysis of Fluid Flow and Heat Transfer by Means of a Unified Model in a Direct Current Electric Arc Furnace

Numerical Analysis of Slag–Steel–Air Four-Phase Flow in Steel Continuous Casting Model Using CFD-DBM-VOF Model

Mathematical Modeling of Fluid Flow in Bath during Combined Side and Top Blowing AOD Refining Process of Stainless Steel: Application of the Model and Results