Abstract:Ferritic stainless steels are candidate interconnect materials for solid oxide fuel cells (SOFC); however, the oxidation resistance of commercial stainless steels within the operating temperature range of 700–800°C is not adequate. A relatively thick, poorly conducting oxide layer forms on the surface of the stainless steel interconnect, decreasing cell performance. One way of modifying the oxidation behaviour of an alloy is through surface treatment. The aim of this work is to perform a systematic study of the effect of surface treatment (sandblasting and cold rolling) on the oxidation behaviour of three different ferritic stainless steels at 800°C in air. Oxidized specimens are characterized using X-ray diffraction (XRD) and scanning electron microscopy (SEM). In addition, specimens oxidized under the same conditions for 15min are examined using secondary ion mass spectrometry (SIMS) depth profiling and X-ray photoelectron spectroscopy (XPS) depth profiling.For all three steels, the as-is (undeformed) specimens have a lower mass gain than the deformed specimens. The steel with the highest Cr content has significantly higher mass gains than the other two steels, which have similar mass gains. X-ray diffraction and electron microscopy results indicate that the oxide scale formed on all the specimens consists of an inner layer of chromia and an outer spinel layer. The relative amounts of the two oxide phases present depends on both the steel and treatment condition. The presence of insulating oxides at the metal/oxide interface is detected with both surface science techniques and electron microscopy.

Lower temperature aluminizing and its effect on improving corrosion resistance of iron treated by surface mechanical attrition treatment

Strain-induced Refinement and Thermal Stability of a Nanocrystalline Steel Produced by Surface Mechanical Attritiontreatment

Effect of Surface Mechanical Attrition Treatment on Microstructure and Oxidation Behavior in T91 Steel at High Temperature

Effects of Heat Treatments on Phase Structure of Electrodeposition Aluminum Coatings on Different Substrates

Effect of Surface Mechanical Attrition Treatment on Corrosion Behavior of 316 Stainless Steel

Preparation of Al-Cr-Fe Coatings by Heat Treatment of Electrodeposited Cr/Al Composite Coatings

Heat Treatment of Aluminum Coating Electrodeposited on Ferritic Stainless Steel at Room Temperature Molten Salts

Improving Corrosion Resistance of Low Carbon Steel through Surface Mechanical Attrition Treatment Duration

The effect of heat treatment on the microstructure and electrochemical corrosion behavior of multilayer AA6061 alloy fabricated by additive friction stir deposition

Enhancing the Ag Precipitation by Surface Mechanical Attrition Treatment on Cu-Ag Alloys

Effect of Heat Treatment on the Passive Film and Depassivation Behavior of Cr-Bearing Steel Reinforcement in an Alkaline Environment

Role of gradient nanograined surface layer on corrosion behavior of aluminum 7075 alloy

Effect of Rare Earths Elements and Surface Mechanical Activation Treatment on the Aluminizing Process for 316L Stainless Steels

Effect of Heat Treatment on the Microstructure and Corrosion Behavior of Arc-Sprayed FeCrAl/Al Coating

Effect of Surface Mechanical Attrition Treatment on Biodegradable Mg-1Ca Alloy.

A Coupled EBSD/TEM Analysis of the Microstructure Evolution of a Gradient Nanostructured Ferritic/Martensitic Steel Subjected to Surface Mechanical Attrition Treatment

Effect of Temperature Treatment on Microstructure and Electrochemical Properties of 6061 Aluminum Alloy

The effect of surface treatment on the oxidation of ferritic stainless steels used for solid oxide fuel cell interconnects

Effect of austenitization on microstructure and corrosion resistance of Al-10Si-xZn-yMg coating

Surface Nanocrystallization of Mg-3 Wt.% Li-6 Wt.% Al Alloy by Surface Mechanical Attrition Treatment

Electron microscopy study of the impact of solution treatment on the corrosion behavior of an Al-Zn-Mg-Cu alloy