Abstract:Reactive magnetron sputtering deposition technique was used for formation of gadolinium doped ceria oxide (GDC) thin films 5- 10µm. Material characteristics and chemical compositions of GDC films were investigated by X-ray diffraction (XRD), scanning electron microscopy (SEM) and 3D profilometry. In order to optimize the deposition of GDC to obtain high electrochemical performance of the cells, the influence of film thickness is studied. The GDC thin films were deposited on porous NiO–GDC (nickel oxide–Gadolinium stabilized ceria), the pre-sintered anode green tape were coated with a GDC electrolyte film by reactive magnetron sputtering using PEM (Plasma Emission Monitoring). An Alcatel SCM650 sputtering chamber was used for synthesizing the dense GDC layers. A Ce-Gd metallic target (90-10% at) was powered by a pinnacle + pulsed current generator from Advanced Energy. The structural, microstructural and morphological features of the half-cells were determined by XRD, SEM and 3D profilometry as deposited and after different annealing treatments. The obtained half-cell, 28 mm of diameter, anode supported solid oxide fuel cell, the porous and density of Ni-GDC10 composite anodes have been elaborated by tape casting method. The chosen ceramic powders in suspension were prepared with the mass ratio of 65:35 for NiO to GDC10. The microstructural morphological /porosity/surface features of the half-cell were analyzed by Scanning Electron Microscopy (SEM), XRD and 3D profilometry before and after different annealing treatment. Pycnometry and porosimetry techniques were primarily used to determine pore size and pore volume by equation Washburn and Ideal gas law-method. Finally, the EIS (Electrochemical Impedance Spectroscopy) measurements were done on Ni-GDC10/GDC10 half-cells under 60 sccm nitrogen by the means of a Solartron SI 1260 impedance / gain analyser from 20 MHz to 0.1 Hz with 11 points per decade.

Review of Potential Parameters for Gadolinium Doped Ceria

Measurement of Emf in Liquid Sodium Using A Gadolinia-Doped Ceria Solid Electrolyte

Thermomechanical Properties of Non-Stoichiometric Gadolinium Doped Ceria by Molecular Dynamics Simulations

Semi-ab initio interionic potential for gadolinia-doped ceria

Molecular dynamics simulation of a gadolinia-doped ceria

Molecular Dynamics Simulations of the Deformation Behavior of Gadolinia-Doped Ceria Solid Electrolytes under Tensile Loading

Modelling Bulk and Surface Characteristics of Cubic CeO2, Gd2O3, and Gadolinium-doped Ceria using a Partial Charge Framework

Anisotropic Mechanical Behavior of Gadolinia-Doped Ceria Solid Electrolytes under Electromechanical Coupling Field Using Atomistic Simulations

Investigation of electrolyte parameters on the performance of gadolinium-doped ceria–based solid oxide fuel cell: an analytical study

Effect of Gd (Sm) doping on properties of ceria electrolyte for solid oxide fuel cells

Properties of Gadolinium-doped Ceria (GDC) Films Deposited by Reactive Magnetron Sputtering Processes

Preparation and Properties of Gd3+ and Y3+ Co-Doped Ceria-Based Electrolytes for Intermediate Temperature Solid Oxide Fuel Cells

Study on Multi-Doped Ceria-Based Solid Electrolytes

Synthesis and Characterization of (gd, Y)-Doped Ceria Electrolytes for Solid Oxide Fuel Cell

Influence of Lithium Oxide Addition on the Sintering Behavior and Electrical Conductivity of Gadolinia Doped Ceria

Design of Supercapacitor Electrodes Using Molecular Dynamics Simulations

Electrical and microstructural characterization of ceramic gadolinium-doped ceria electrolytes for ITSOFCs by sol-gel route

Influence of the Exchange-Correlation Potential and Magnetic Properties on the Li2FeSiO4 Cathode Materials

DFT Investigations on Sintering Behavior of Gadolinia-Doped Ceria with Lithium Oxide Additives

Effects of Sintering Parameters on the Low-Temperature Densification of GDC Electrolyte Based on an Orthogonal Experiment

Preparation of Plasma Sprayed GDC Electrolytes for Metal-Supported Solid Oxide Fuel Cells