Abstract:This paper presents a printed circuit board realization of a K-band portable frequency-modulated continuous-wave radar transceiver with beamforming array for short-range localization. The transmitter channel of the proposed radar consists of a free-running voltage-controlled oscillator (VCO) and a single patch antenna. A linear frequency-modulated chirp signal is generated by the VCO, which is controlled by an analog "sawtooth" voltage generator. The receiver channel has a four-element linear beamforming array, a six-port circuit, and a baseband circuit. The beam of the array can be continuously steered in a range of +/- 45 degrees on the H-plane through an array of vector controllers. Each vector controller is capable of simultaneously controlling the phase and the amplitude of the corresponding array element. The design principle of the binary-phase-shift attenuator, the vector controller, and the radar system are discussed. Calibration method of the array is introduced to minimize the errors caused by component variation and fabrication. The radiation patterns of the array with phase-only beam steering and phase-amplitude beamforming are measured and compared, demonstrating the advantage of the beamforming design. System-level experiments showed that the proposed solution is suitable for short-range localization. In addition, experiments with a human subject revealed the capability of the proposed radar system to discriminate a human target from other objects based on the vital-Doppler effect.

Tracking Radar Digital Matched-Filter ASIC Design

Tracking radar digital matched-filter ASIC design and its error analysis

A FPGA Stereo Matching Algorithm Modeled by DSP Builder.

A Parallel Stereo Matching Algorithm Core for FPGA Modeled by DSP Builder

One-bit LFMCW Radar: Spectrum Analysis and Target Detection

Mass Production Development of 4D Millimeter-Wave Radar Based on a Single Chip

Research on High-speed Detection Method of Radar Signal Based on RFSoC.

Design and Implementation of a Digital Radar Receiver Based on FPGA

A $K$ -Band Portable FMCW Radar with Beamforming Array for Short-Range Localization and Vital-Doppler Targets Discrimination

New method to implement digital down converter in radar system

A High Performance SoPC Based Digital Receiver for Monopulse Tracking Radar

General Radar Signal Simulation,acquisition and Processing System Based on FPGA

Integrated Design of Three Signal Processor Based on FPGA

Design and Implementation of Digital IF Receiver Based on FPGA

A Low Cost And High Performance Design Of X-Band Short Range Doppler Radar Transceiver

A Fast Implementation of Radar Display Based on DSP

Signal Processing for Novel Noise Radar Based on de-chirp and Delay Matching

Angle-Dependent Matched Filtering for Moving Target Indication with Coherent FDA Radar

Design And Fpga Implementation Of Digital Pulse Compression For Hf Chirp Radar Based On Modified Orthogonal Transformation

A Highly Efficient Digital Down Converter in Wide Band Digital Radar Receiver

Design and Realization of Pulse Compression Method of Radar System Based on Fpga