Influence of High-Density Polyethylene and Nano-Calcium Carbonate of Various Content Ratios on the Crystallization of Polypropylene
Yu Zhang,Lei Zhang,Hong Liu,Hainan Du,Xinpeng Li,Xiongwei Zhang,Jie Zhang
DOI: https://doi.org/10.1080/00222348.2012.759019
2013-01-01
Abstract:The influence of high-density polyethylene (HDPE) and nano-CaCO3 of various content ratios on the crystallization of polypropylene (PP) was investigated by differential scanning calorimetry, dynamic rheology, wide angle X-ray diffraction (WAXD), and Izod impact strength measurements. The results showed that HDPE and PP were phase separated in their blends and the additive CaCO3 filler mainly dispersed in the PP phase, acting as a nucleation agent to promote the crystallization of PP. For the samples HDPE/ nano-CaCO3 30/0 and 25/5, the crystals content was much higher than the other samples. The reason is that the viscosity difference between HDPE and PP led to a velocity difference, which could induce shear stress at the interfaces of HDPE and PP during injection molding. The intensive shear stress at their phase interfaces is advantageous for orientation of the chains, inducing the formation of crystals. However, with the increment of CaCO3 content, there were dual effects of CaCO3 on the crystallization of PP: at low CaCO3 content, it would hamper the orientation of PP chains, thus leading to a decrease of crystals; at high CaCO3 content, it would induce crystals by itself.