Abstract:Space charge effect is undesirable for HV and EHV plastic power cable. Up to now, the insulating materials of most DC power cables are traditional modified polyethylene (PE) in order to have superior dielectric properties such as space charge accumulation, volume resistivity, breakdown strength and so on. The common modification can be achieved by various methods such as the uses of additives, blending, grafting and copolymerization. In general, blending is a widely used technique to improve dielectric properties of PE. Based on blending technique, metallocene catalyzed polyethylene (MPE) is blended into low-density polyethylene (LDPE) in this paper. Then the space charge profile in the blends is measured by pulsed electro-acoustic (PEA) method. And at the same time, the volume resistivity of blends is measured by micro-current detector. In addition, the AC breakdown strength of blends is measured by step voltage. It is shown by test results that LDPE blending with 1% of MPE could effectively decrease the space charge effect, increase the AC breakdown strength by 7.9% and slightly reduce the volume resisitivity. The test results of the resistivity are consistent with that of space charges. It is validated that the blending by proper amount of MPE could decrease the deep traps, increase the shallow traps and the charge mobility in LDPE. Polyethylene is a typical semicrystalline including crystal phase and amorphous phase. The electrical breakdown path advances along the boundaries of spherulites, or trans-crystal, or lamella of LDPE, which means that electrical breakdown path go through amorphous area in polymers. So the increase of AC breakdown strength may be related with the micro-structure and crystalline morphology of LDPE, such as the increase of crystal phase and the decrease of amorphous, or the increase of crystallinity can improve the breakdown strength. At the end of this paper, the relation among material structure, charge trap and dielectric properties in the blends is analyzed and discussed.

Charge Trapping and Transport Properties in Low-Density Polyethylene Modified by Metallocene Catalyzed Polyethylene

Charge Transport Property in Polyethylene Investigated by Space Charge Measurement

Study on Mechanism of Space Charge in Low Density Polyethylene Modified by Metallocene Catalyzed Polyethylene

Dielectric Properties in Low Density Polyethylene Modified by Metallocene Catalyzed Polyethylene

Insulation Performance and Microstructure in Modified Polyethylene by MPE

Space Charge Distribution and Crystalline Structure in Low-Density Polyethylene Modified by Metallocene Catalyzed Polyethylene

The Relationship Between Energy Distribution and Space Distribution of Charge Traps in Linear Low Density Polyethylene

Dielectric Properties and Crystalline Morphology of Low Density Polyethylene Blended with Metallocene Catalyzed Polyethylene

Trap-Controlled Charge Decay and Quantum Chemical Analysis of Charge Transfer and Trapping in Xlpe

Dielectric Properties and Mechanical Strength in Low-Density Polyethylene Modified by Metallocene Catalyzed Polyethylene

Space Charge Distribution of Nano-SiC/Low Density Polyethylene Composite

Space Charges Formed in the Hot Compression Molding Process of Low Density Polyethylene

A Space Charge Trapping Model and Its Parameters in Polymeric Material

Formation and Inhibition Mechanisms of Space Charges in Direct Current Polyethylene Insulation Explained by Energy Band Theory

Study On The Detrapping Of Charge Carriers In Polythylene Films

Packet-Like Space Charge Dynamics In Polyethylene With Various Crystallinity

An Electron and Hole Trap Energy Distribution Estimation Model and Its Application in Polypropylene Nanocomposites

Effect of trap level density on breakdown strength and space charge distribution of polypropylene/low‐density polyethylene composites

Trap Modulated Charge Carrier Transport in Polyethylene/Graphene Nanocomposites

Study on space charge in LDPE blended by LLDPE

Investigation of Charge Trapping and Detrapping Dynamics in LDPE, HDPE and XLPE