Centrifuge Model Test of the Seismic Response Behavior of a Sand Slope

YU Yuzhen,DENG Lijun,LI Rongjian
DOI: https://doi.org/10.3321/j.issn:1000-0054.2007.06.009
2007-01-01
Abstract:A centrifuge model test of a sand slope subjected to an El Centro earthquake was carried out on a centrifuge shaking table at 50 gravitational accelerations to investigate the seismic response behavior of sand slopes.Acceleration time histories were recorded by accelerometers at different locations on the model to calculate the response spectra.The maximum response occurred at the crest where the peak spectrum amplification factor was 4.78.Different constituent frequencies of the input motion spectrum were amplified to different degrees.The constituent frequency with the maximum amplification factor was 5.7-6.7 Hz.The slope response was amplified as the seismic motion propagated upwards through the slope.The response of the upper layer was greater than that of the lower layer while the response of the zone adjacent to the inclined surface was greater than that of the internal slope.
What problem does this paper attempt to address?