Abstract:The employment of atmospheric pressure plasma jets (APPJs) in a large sort of applications is limited by the adversities related to the size of the treated area and the difficulty to reach the target. The use of devices that employ long tubes in their structure has contributed significantly to overcome these challenges. In this work, a comparison between two different plasma systems employing the jet transfer technique is presented. The main difference between the two devices is how the long plastic tube was assembled. The first one uses a copper wire placed inside a long plastic tube. The other device has a metallic mesh installed in a concentric arrangement between two coaxial plastic tubes. As a result, the two APPJ systems exhibit different properties, with the wire assembly being more powerful, also presenting higher values for the electrical current and rotational temperature when compared to the mesh mounting. X-ray photoelectron spectroscopy (XPS) demonstrates that both configurations were capable of inserting O-containing functional groups on the polypropylene (PP) surface. However, the transferred plasma jet with wire assembly was able to add more functional groups on the PP surface. The results from XPS analysis were corroborated with water contact angle measurements (WCA), being that lower WCA values were obtained when the PP surface presented higher amounts of O-containing groups. Surface morphology evaluation showed that the plasma treatment tends to slightly increase the surface roughness of the PP samples with both wire and mesh configurations. Furthermore, the findings in this work suggest that the APPJ with wire configuration is more appropriate for material treatments, while the transferred jet with mesh arrangement tends to present lower electrical current values which makes it more suitable for biological applications.

10 Ns Pulsed Atmospheric Air Plasma for Uniform Treatment of Polymeric Surfaces

Atmospheric Air Homogenous DBD Plasma Excited by Bipolar Nanosecond Pulse Used for Improving the Hydrophilic Property of Polypropylene

Experimental Study of Accelerating Surface Charge Dissipation on Polymer Treated by Repetitively Pulsed Discharge Plasmas

Repetitive Nanosecond-Pulse Dielectric Barrier Discharge and Its Application on Surface Modification of Polymers

Large-area and uniform surface modification of polymers by barrier discharge plasmas

Characteristics of Unipolar Nanosecond Pulse DBD andIts Application on Surface Treatment of Polyimer Films

Large-Area Surface Modification of Polymers Using A Cold Pulsed Glow Discharge

Hydrophilic Improvement of Polymers Treated by Homogeneous Nanosecond Pulse Dielectric Barrier Discharge in Atmospheric Air

Low temperature atmospheric microplasma jet array for uniform treatment of polymer surface for flexible electronics

Improvement of Polytetrafluoroethylene Surface Energy by Repetitive Pulse Non-Thermal Plasma Treatment in Atmospheric Air

Atmospheric Dielectric-Barrier Discharges Scalable from 1 Mm to 1 M

Surface Treatment of PET and PP by Atmospheric Pressure Dielectric Barrier Discharge for Improvement in Hydrophilicity

Experimental Study of Nanosecond Pulsed Barrier Discharges in Air Manipulated by Pulse Width

Surface Treatment by Dielectric Barrier Discharge with Wire Mesh Electrodes

Surface Modification of Polyimide Films Using Unipolar Nanosecond-Pulse DBD in Atmospheric Air

An atmospheric-pressure plasma brush driven by sub-microsecond voltage pulses

Polypropylene Surface Plasma Modification Using Middle Frequency Power Supply

Surface activation of thin polyvinyl alcohol films by atmospheric pressure plasma jet: Influence of electron temperature

Different configurations of transferred atmospheric pressure plasma jet and their application to polymer treatment

Surface electric charge decay behavior of Polypropylene (PP) films treated by atmospheric air dielectric barrier discharge

Production of Atmospheric Pressure Diffuse Nanosecond Pulsed Dielectric Barrier Discharge Using the Array Needles-Plate Electrode in Air