Influence of Different Compacting Methods on Mix Design of Semi-rigid Base Materials

Long WANG,Xiaoguang XIE,Lize YU

DOI: https://doi.org/10.3969/j.issn.1002-0268.2013.02.006

2013-01-01

Journal of Highway and Transportation Research and Development

Abstract:The influence of vibration compaction and static compression method on mix design of cement stabilized macadam roadbase materials is researched and the reason of the difference is analyzed.Vibration compaction is applied for cement stabilized macadam in test,the physical and mechanical indexes are measured after curing,and the property of vibration compacted cement stabilized macadam is compared with that of the standard compacted(static compressed) specimens.The experiment results show that(1) the relation between optimum water content and maximum dry density of vibration compacted cement stabilized macadam and standard compacted specimens is linear,the maximum dry density of vibration compacted material increases 0.04 g/cm3 compare to that of standard compacted specimens,increasing range at around 1.8%;(2) the specimens' height control precision of static pressure molding is below than that of vibration molding,and deviation is bigger;(3) the vibration molding specimens' strength increases by 70% than that of static compaction molding overall,60% of the increase in the strength comes from skeleton embedded role;(4) according to the test results,the failure of the structural effect of gradation and the inaccurate sample height control which make represent compressive strength higher are the main factors resulting in the higher cement dosage in design cement stabilized macadam mixing ratio using static compression method.