Abstract:Electrical discharge machining is widely used in aerospace industries, semiconductor applications, micro-electromechanical systems, and other fields of the machining of micro-holes, micro-shafts, and micro-structures due to non-contact stress during the electrical discharge machining process. In the electrical discharge machining process, the machining precision of electrical discharge machining depends on the dimensional precision of the tool electrode, therefore, the machining process of microelectrode has attracted growing concern. In this study, a thermal model of the microelectrode machining process was proposed to simulate the formation process of microelectrode based on the temperature distribution during block electrical discharge grinding of the microelectrode process. According to the microelectrode machining process, the thermal model considers the main influential factors such as random distribution of discharge points, time-dependent discharge channel radius, Gauss heat source, phase transformation latent heat, etc. Through the thermal simulation analysis, the temperature distribution and the dynamic spark-erosion process of the microelectrode based on random repetitive spark discharges were obtained during block electrical discharge grinding of the microelectrode. Besides, it is found that the maximum temperature value and discharge crater volume of the electrode surface fluctuate and gradually decrease with the increase of discharge times. In addition, the effect of pulse width on the machining process of microelectrode was investigated by numerical simulation and block electrical discharge grinding of microelectrode experiment. The results indicated that the crater volume and the maximum temperature value on the surface of the microelectrode increased with the increase of pulse width. The formation process of microelectrode was considered a significant indicator to determine the machining precision and machining efficiency of the electrical discharge machining process.

The influence of frequency to the inter-electrode gap in high frequency group pulse electrochemical machining

Influence of Pulse Waveform on Machining Accuracy in Electrochemical Machining

Research on Electrochemical Machining with Synchronization of Pulse Current and Low-frequency Vibration

Influence of superimposed pulse position in superimposed pulse current waveform on surface integrity in electrical discharge machining

On-line Gap Monitor and Control in HSPECM

Influence of Electrolytic Products in Machining Gap on Micro ECM

Gap status identification and control of wire electrochemical micromachining

Study on characteristics of EDM using pulse power supply with active high-frequency oscillation

Study on Overlap Rate of Discharge Craters Based on Finite-Continuous Pulse Discharges

Research on influence rules of electrode machining time on EDM efficiency

Effect of Electrode Jump Motion on Machining Debris Concentration

Analysis on the Influence of Electrode Jump Height and Speed for Machining Stability in EDM

Pulsed Power Supply Superposed With Radio Frequency Oscillating Wave for the Improvement of Micro-Electrical Discharge Machining Process

Effects of Machining Parameters on Electrochemical Multi-Field Coupling

Study on Electrode Vibration in the Touch-Down Stage of Fast Electrical Discharge Machining Drilling

Computational Fluid Dynamics Analysis of Working Fluid Flow and Machining Debris Movement in End Electrical Discharge Milling and Mechanical Grinding Compound Machining

Research on machining Technology of Electrospark-electrochemical Hybrid Energy Field with tungsten hole

Pulsed Power Supply Superposed with RF Oscillating Wave for the Improvement of Micro EDM Process

Surface-improvement mechanism of hybrid electrochemical discharge process using variable-amplitude pulses

Thermal simulation of microelectrode machining process during block electrical discharge grinding

Research on the High Frequency Pulse Generator of Electrochemical Machining Based on CPLD