Abstract:The grafting of pH-responsive poly(acrylic acid) (PAA) brushes was carried out on the surface of a commercial TFC-PA membrane using surface-initiated atom transfer radical polymerization (SI-ATRP). Poly(t-butyl acrylate) was polymerized through the SI-ATRP method followed by its acid hydrolysis to form PAA hydrophilic polymer brushes. Surface morphology, permeation flux, salt rejection, and pore sizes were investigated. The contact angle for water was reduced from 50° for a pristine membrane to 27° for the modified membrane due to a modification with the hydrophilic functional group and its brush on membrane surfaces. The flux rate also increased noticeably at lower pH values relative to higher pH for the modified membranes, while the flux remains stable in the case of pristine TFC-PA membranes. There is slight transition in the water flux rate that was also observed when going from pH values of 3 to 5. This was attributed to the pH-responsive conformational changes for the grafted PAA brushes. At these pH values, ionization of the COOH group takes place below and above pKa to influence the effective pore dimension of the modified membranes. At a lower pH value, the PAA brushes seem to permit tight structure conformation resulting in larger pore sizes and hence more flux. On the other hand, at higher pH values, PAA brushes appeared to be in extended conformation to induce smaller pore sizes and result in less flux. Further, pH values were observed to not significantly affect the NaCl salt rejection with values observed in between 98.8% and 95% and close to that of the pristine TFC-PA membranes. These experimental results are significant and have immediate implication for advances in polymer technology to design and modify the “switchable membrane surfaces” with controllable charge distribution and surface wettability, as well as regulation of water flux and salt.

Ph‐induced On–off Switching of Polycarbonate Track‐etched Membranes by Plasma‐induced Surface Grafting

Thermally On−Off Switching Membranes Prepared by Pore-Filling Poly(N-isopropylacrylamide) Hydrogels

Microstructures and thermo-responsive characteristics of poly(N-isopropylacrylamide)-grafted polycarbonate track-etched membranes prepared by plasma-graft pore-filling polymerization

Functional and Surface-Active Membranes from Poly(vinylidene Fluoride)-Graft-poly(acrylic Acid) Prepared Via RAFT-mediated Graft Copolymerization.

Characterization of microstructure of poly(-isopropylacrylamide)-grafted polycarbonate track-etched membranes prepared by plasma-graft pore-filling polymerization

Surface Modification of Poly(tetrafluoroethylene) Films Via Plasma Treatment and Graft Copolymerization of Acrylic Acid

Thermo- and Ph-Responsive Polypropylene Microporous Membrane Prepared by the Photoinduced Raft-Mediated Graft Copolymerization

Preparation of Functional Track Membranes by Photografting Polymerization

Acrylic Acid Grafted Porous Polycarbonate Membrane with Smart Hydrostatic Pressure Response to Ph

Graft Polymerization of Acrylic Acid on A Polytetrafluoroethylene Panel by an Inductively Coupled Plasma

Surface Modification of TFC-PA RO Membrane by Grafting Hydrophilic Ph Switchable Poly(Acrylic Acid) Brushes

Synthesis of Ph-Responsive Polyethylene Terephthalate Track-Etched Membranes by Grafting Hydroxyethyl-Methacrylate Using Atom-Transfer Radical Polymerization Method

Ar Plasma-induced Graft Polymerization of Acrylic Acid Onto PTFE Films

Radiation Induced Grafting of Acrylic Acid Onto Polycarbonate Membranes

New Ph-Switch Nucleopore Membranes Prepared by Photografting

Synthesis and Characterization of Poly(acrylic Acid)-Graft-poly(vinylidene Fluoride) Copolymers and Ph-Sensitive Membranes

Thermo-sensitive switching membranes regulated by pore-covering polymer brushes

Tunable Wettability and Ph‐responsiveness of Plasma Copolymers of Acrylic Acid and Octafluorocyclobutane

PREPARATION OF STIMULI-RESPONSIVE MEMBRANE BY PLASMA GRAFT POLYMERIZATION OF POLY(N-ISOPROPYLACRYLAMIDE) ONTO PE MEMBRANE

Temperature-sensitive membranes prepared by the plasma-induced graft polymerization ofN-Isopropylacrylamide into porous polyethylene membranes

Hydrophilic Modification of Microporous Polysulfone Membrane Via Surface-Initiated Atom Transfer Radical Polymerization and Hydrolysis of Poly(Glycidylmethacrylate)