Abstract:Building Services Engineering Research and Technology, Ahead of Print. To meet the functional requirements of high-rise buildings, drainage stacks usually employ an offset pipe in the structural transfer floor. At the offset point, the flow direction changes and the air pressure fluctuates, which significantly influences the drainage system capacity and water seal effectiveness. Different offset modes have different degrees of influence on drainage characteristics. To better understand the influence of different offset modes on drainage characteristics, five different test conditions in double stack building drainage systems were established and investigated. DS1 was a standard double-stack drainage system with anti-reflux H-tube joints for every two floor levels. The remaining four systems were developed from DS1 by adopting various offset pipes (or pipe joints) on the fourth floor. DS2 adopted an S-shape offset pipe joint at the offset point. DS3 adopted double S-shape offset pipe joints. DS4 adopted a 1.0-m-long horizontal offset pipe. DS5 adopted a 1.5-m-long horizontal offset pipe. The pressure fluctuations and water seal losses were chosen as the experimental parameters to determine the maximum discharge capacity according to the Standard for Capacity Test of Vertical Pipe of the Domestic Residential Drainage System CJJ/T 245. The experimental results demonstrated that the installation of offset pipes (or pipe joints) contributed to the abrupt positive pressure and severe water seal losses at the position where flow direction shifted. As the length of the offset pipe increased, the positive pressure was more severe, and maximum discharge capacity was minor. The relationships among the maximum discharge rate, pressure fluctuation limits, and water seal losses are discussed. Lastly, a nondimensional analysis was adopted to understand the relationship between water seal losses and pressure limit values under different discharge rates for current test facilities.Practical application: Pipe offset has the potential to influence a drainage system discharge capacity. As the length of the horizontal offset pipe increases, the discharge capacity will decrease. In the actual design, the length of the offset pipe section should be reduced and this study demonstrates that the application of S-shape offset pipe joints is an efficient solution.

Research on application of new gas-water separator in single stack drainage system

Experimental Study on Air Pressure Variation in a Horizontal Pipe of Single-Stack Drainage System.

Study on Numerical Simulation of Hydraulic Regime of Single Stack Drainage System

Numerical Investigation on Bottom Shear Stress Induced by Flushing Gate for Sewer Cleaning.

Numerical Simulation and Experimental Investigation of Flow Field in Gas-Liquid Cylindrical Separator with Baffle Configuration

Experimental Study and Numerical Simulation of the Characteristics of a Percussive Gas–solid Separator

Simulation research on the flow field performance of the supersonic separator for natural gas

Discussion on Relationship between Pressures at Sink Traps and Horizontal Drainpipe

Experimental Study on a New Type of Separator for Gas Liquid Separation

Research on the Performance of a Passive Gas-Liquid Separator Used in Space

Experimental Study on the Hydraulic Performance of the Horizontal Main Drain of Building Drainage Systems with Solid Waste

Integrated design of multi-stage membrane separation for landfill gas with uncertain feed

Influence of unsaturated soil layer thickness and inflation pressure on water drainage efficiency

Structure modification and numerical study of the moisture-separation performance of special crossunder pipe separators for nuclear power steam turbines

Influence and mechanism of solids on the air pressure fluctuations on the building drainage system

Experimental Study on Two Different Gas-Liquid Separators Under Different Flow Patterns

Experimental research and numerical analysis for effect of drainage structure on separation performance and the "blockage" of fluid in nozzle

The influence of different offset modes on the drainage characteristics of a double stack drainage system in a high-rise building

Study on improvement of water distribution and three-phase in exterior circulation anaerobic process

Numerical Simulation on Effect of Separation Caused by Different Internal Setting in Gravitational Oil-Gas-Water Separator

Simulation and Experimental Validation of a New Separator Design for a Wide Range of Gas Volume Fractions