Abstract:On the basis of previous experimental studies of two-phase flow condensation heat transfer for R134a inside the horizontal micro-fin tubes, a theoretically analysis of heat transfer characteristic combining both heat transfer mechanism and flow mechanism is discussed by the experimental data of heat transfer coefficient and pressure drop, to further clarify the influence of experimental condition and tube structure on heat transfer characteristics under the special working condition. Two performance factors, enhancement factor (EF) and penalty factor (PF), are introduced to quantitatively compare the effect of micro-fin on the heat transfer coefficient and the pressure drop between enhance tube and smooth tube. Meanwhile, the comprehensive factor, CHF, is applied to evaluate the comprehensive performance of heat transfer tube. It was found that enhancement factor (EF) and penalty factor (PF) both increase with increasing mass flux and fin helical angle, and decreasing saturation temperature, the comprehensive factor, CHF, is always greater than one and increases with increasing fin helical angle and mass flux, and decreasing saturation temperature. Moreover, based on the comparative analysis findings that some existing correlations of heat transfer characteristics underestimate most of the experimental data, and the experimental variable has great influences on the correlation prediction accuracy, such as mass flux, which is proportionate to the prediction deviation of correlation. Therefore, a new correlation was developed through analyzing quantitatively influencing mechanism of the experimental variable on the heat transfer characteristics, in a way that a two-phase frictional multiplier is defined firstly from the experimental data and then the forced convection heat transfer mechanism is redefined based on the comprehensive effect of various experimental variables. By the experimental data verification, the new correlation shows good prediction effect with the mean deviation of less than 5%.

Optimization to the Tube–fin Contact Status of the Tube Expansion Process

A New Approach in Evaluation of Thermal Contact Conductance of Tube–fin Heat Exchanger

Numerical and Experimental Study on Expansion Forming of Inner Grooved Tube

Design optimization of a high-temperature fin-and-tube heat exchanger manifold – A case study

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Analysis of Fin-Tube Joints in A Compact Heat Exchanger

Simulation and Optimization Study on the Performance of Fin-and-Tube Heat Exchanger

Performance Simulation and Structure Optimization for Fin -tube Heat Exchanger in Air Handle Unit

Thermal-Hydraulic Performance and Optimization of Tube Ellipticity in a Plate Fin-And-Tube Heat Exchanger

Enhancing heat transfer efficiency in corrugated tube heat exchangers: A comprehensive approach through structural optimization and field synergy analysis

Numerical Study on Optimization Design of Circuit Arrangement for Tube-Fin Heat Exchanger

Optimization of H-type finned tube heat exchangers with combinations of longitudinal vortex generator, dimples/protrusions and grooves by Taguchi method

Hydraulic Expansion Joint Contact State of Heat Exchanger Based on New Contact Area Measurement Method

HEAT TRANSFER ENHANCEMENT IN INSERTED EXTRUDED ALUMINUM FINNED TUBES

A numerical study on compact enhanced fin-and-tube heat exchangers with oval and circular tube configurations

Knowledge Based Genetic-Simulated-annealing Method for Optimizing Tube Circuit of Fin-and-tube Heat Exchangers

Mechanical Expansion of Thick-Walled Microgroove Tube for High Pressure Acr System

A New Performance Evaluation Method and Its Application in Fin-Tube Surface Design of Small Diameter Tube

Experimental and numerical investigation on air-side performance of fin-and-tube heat exchangers with various fin patterns

Parametric Study and Optimization of H-type Finned Tube Heat Exchangers Using Taguchi Method

Numerical investigation on effects of using segmented and helical tube fins on thermal performance and efficiency of a shell and tube heat exchanger